Title Page
-
Tram No:
-
Prepared by
-
Date
-
Depot conducted
Pre-check modules
FAT Quality Checklist - Refer to "Functional checks at power on" document
Cab-2 I/O and ADAMS Device check
-
End 2 - Ignition key OFF<br><br>Verify the following functions:<br> 47-K04 - Relay Light is "ON"<br> ADAMS DI3 is less than 1V
-
End 2 - Ignition Key ON<br><br>Verify the following functions:<br> 47-K03 - Relay Light "OFF"<br> 47-K04 - Relay Light "OFF"<br> ADAMS DI2 and DI3 are between 7V to 9V
Drivers Cabin - Camera Select End 2, Press camera select button (right button - drivers arm rest)
-
D1 - Does camera cycle through 1-4 then back to 1?<br> D2 - Does camera cycle through 1-6 then back to 1?
-
Does the camera numbers match the door numbers?
-
Are the video image's crisp, color is true, and no pixilation's or dead pixels?
End 2 - Genetec 2 Monitor [Driver Monitor]
-
End 2 Cabinet - Locate wire E22811.04 in Terminal 58 and remove it When wire disconnected, does the relay light go off, and the Genetec display go to the Color background?
- Pass
- Fail
- N/A
-
End 2 Cabinet - Connect wire E22811.04 in Terminal 58<br><br>When wire is connected, does the display goes back to the CCTV footage?
End 2 - Door Test
Press Front Door Open
-
Confirm the following functions:<br>47-K05 - light is off<br>ADAMS DI4 voltage between - 7V to 9V
Close all Doors
-
Does Relay Light 47-K05 turn on when ADAMS DI4 is less than 1V, ONLY when all doors are closed.
End 1 - Driver's Display
-
Go to end 1, turn the ignition key on End 1<br><br>Verify the following test<br> 1. Video is Crisp, color is relatively true, no pixilation's or dead pixels<br> 2. Relay light illuminated on 47-K03, ADAMS DI2 is less than 1V
Camera Disconnection Test
-
Disconnect any camera<br><br>1. Relay 47-K07 light goes on 30s - 1min after disconnection.<br>2. Wait 30s to 1 min, check the Klipstation alarms (drivers right hand side console). <br>3. Press the camera select button<br><br>Check the disconnected camera comes up with no CCTV footage
OCMS Test
-
Ask OCMS person to generate a computer fault<br><br>Wait 30s - 1min, check Klipstation alarms to verify fault
OCMS - GPS/ 5G Testing
-
Ask OCMS person to check wireless connections<br><br>Test<br> 5G is connected and GPS shows location at current location/ depot<br> Name of the tram in Genetec matches actual tram<br>
