Title Page
-
Crane/Hoist Model and Serial Number
-
Lifting Capacity
-
Inspected by
-
Inspected on
-
Location
-
WARNING: Disconnect power and discharge the capacitor on single phase units before inspecting hoists.
Structural Support System
-
Mounting Base
-
Vertical Support Column
-
Horizontal Support Column
-
Support and Beam - Maximum rated capacity stenciled on the beam.
Main Hoist
-
Clean the chain by removing any foreign material such as dirt and grease and inspect the chain for wear using a gauge.
-
Slack the chain and observe if wear exists at interlink bearing surface between the links.
-
Inspect the chain for gouges, nicks, arc burns, twisted, bent, worn or damaged links.
-
Inspect the loose end-link, loose end screw and dead end block and clevis pin on the double reeved units.
-
Inspect sheave wheel for freedom of movement.
-
Mechanical load spring break
-
Electric brake
-
Lower hook and throat opening measurement
-
Upper hook
-
Hook swivel
-
Hook pin
-
Chain drum
-
Guards
-
Limit switches
Operational
-
Inspect that all connections are made and screw terminals are tight.
-
Check the groundscrews to see that the ground wires of the pendant push button cable and power cord are secure.
-
Master switch
-
NOTE: After the inspection, lubricate the chain with a light coat of penetrating oil and graphite.
Sign Off
-
Name and signature of inspector