Title Page
-
Prepared by
-
Location
-
Conducted on
Inspection Results
-
Traffic Management - If Yes; Brief description of required setup (Road Closure/Contraflow etc.)
-
Lift Inner and Outer Lid - Pass If Two Piece Lid, Fail If One Piece
-
Clean & Denso Grease
-
Check Chamber Heights - Need >290mm from brass seat to underside of chamber lid. Need 100mm below brass seat to dirt
-
Clean Chamber: Flush Fireplug & Vac Out Chamber (100mm clear below fireplug seat)
-
Clean Brass Fireplug Seat - New/Blue Fireplugs leave as is (Avoid damaging it)
-
Fireplug Spindle and Seal Check<br>1. Install Fireplug Dummy<br>2. OPEN Fireplug and Check Spindle Doesn't Leak<br>3. Create Follow Up W/O if Spindle Does Leak<br>4. If Dummy Does Not Seal, Try Again and If Not, Add Comments.
-
Measure Distance To Kerb - Measurement from Centre of Fireplug Lid to Closest Kerb
-
Site photos - Take Photos into Fireplug Chamber, Site Setup & Fireplug Location
