Information
-
Audit Title
-
Document No.
-
Operator
-
Conducted on
-
Prepared by
-
Location
-
Personnel
Equipment
-
Type of forklift? IE: variable reach, fixed mast, etc. Give as much detail as possible.
Daily Safety Inspection
-
The operator completes the safety Pre-shift safety inspection correctly
-
The operator fully understands the capacity information plate?
-
The operator understands the correct fault reporting procedures?
-
If a fault has been found, the lift truck must be parked up in a safe place and the key removed. The fault must be made to a member of the management team.
Operator Safety & Observation
-
The operator mounts / dismounts correctly?
-
Keeps body parts within the confines of the vehicle?
-
Operator looks in the direction of travel?
-
Correct use of the horn when appropriate?
-
Follows the correct procedures for an "unattended" vehicle?
-
Operator had good all round safety observation?
Steering & Operating Controls
-
Starts and stops smoothly?
-
Uses the seatbelt correctly?
-
Correct use of the steering assistor?
-
Travels unintentionally in the wrong direction?
-
Brakes harshly / erratically?
-
Releases the parking brake prior to moving off?
-
Operator rides the foot brake?
-
Operates the hydraulic controls when the lift truck is in motion?
-
Rough use of hydraulic controls?
-
Operates and understands the controls?
Competency In Load Capacity
-
Operator matches load with the trucks capacity?
-
Operator knows the approximate weight of the load?
-
Operator checks the load for stability?
Maneuvering & Transportation
-
Forks to high when traveling?
-
Forks to low when traveling?
-
Operating in reverse, looking in the direction of travel to the correct ratio?
-
Operates at a speed consistent with the type of load and working conditions?
-
Operator performs safe maneuvring with the lift truck and load!
Stacking & de-stacking
-
Incorrect set down at a vertical face?
-
Operator applies the park brake when operating the hydraulics?
-
Operator applies neutral when operating the hydraulics?
-
Fork arms central under the load?
-
Fork arms not rubbing (entry / withdrawal)?
-
Fork tips touch the stack / load?
-
Forks / load not tilted back towards carriage?
-
Load correctly stacked?
-
Forks not fully inserted (Undercut)?
-
It is some times necessary to undercut a load due to the nature of where it is to be located. It must remain within the limits of the capacity plate.
Parking
-
The operator correctly applies the park brake?
-
The operator sets the direction lever to the neutral position?
-
The operator correctly apples forward tilt?
-
The operator correctly lowers the fork arms?
-
The maneuvring wheels are in the straight position?
-
The operator switches off the lift?
Assessment Recommendations & Evaluations
-
Assessors evaluation of operator safety?
-
Comments
Signatures
-
Date and time of assessment
-
Operator signature
-
Assessor signature