IDI Spray Paint

Confirm for updated drawings, RFI's, plans & specs

Have all draw-downs been submitted and approved

If precast or concrete, does the substrate need to be power washed

Confirm that all items not to receive paint have been protected from overspray

Confirm that duct work or any other form of air movement has the correct filters installed to reduce fume transfer

Are all surfaces free of rust, stains, fireproofing, or anything else that may cause a flaw to the finish surface

Confirm that all substrates are at the correct temperature to receive material

Confirm that all substrates are not wet or contain too much moisture

If precast or concrete, is the pH level at an acceptable range

Is the wind calm enough not to cause overspray to carry a distance

Have all trades either moved or protected their stored materials from overspray

Are all MEP's complete before spray

Have sprinkler heads been protected from spray

Have smoke detectors been protected from spray

Confirm the paint is the correct product from the correct manufacturer

Are all coatings applied to the correct MIL thickness

Do all sprayed surfaces have a uniform finish

Have all protection materials (i.e. tape, plastic, foil) been removed from items that were being protected (i.e. hinges, convectors, sprinkler heads)

Look for imperfections before the architect creates the punch list

Confirm clean-up of our material and scrap

Did you walk and inspect the job site with the G.C.