Information
-
Document No.
-
Audit Title
-
Client / Site
-
Conducted on
-
Prepared by
-
Location
-
Personnel
-
Vehicle Description
-
Vehicle Registration
-
Vehicle Owner
-
Odometer/ Hour Reading
-
NOTE: The Greasing and further inspection will be carried out at weekly intervals as per RT655 operators guide contained within workshop and logged in register. Grease lines and grease points much be checked for any blockage
1.0 Rear Door
-
1.1 - check locking bolts (wing nut device attached)
-
1.2 - check swing frame pins and mounts are in good condition
-
1.3 - check hydraulic cylinder for serviceability
-
1.4 - check condition of seals
- Compliant
- Not Compliant
- Not Applicable
-
1.5 - check inlet sucker hose for visible leaks
-
1.6 - check hose condition
-
1.7 - check for wear, cracks, welds and Structual damage
-
Add media
2.0 Internal Body Shell
-
2.1 - check pins and split pins
-
2.2 - check cylinder mount box
-
2.3 - Check the general condition of the internal body
-
2.4 - visual check all weld areas
-
Add media
3.0 Engine Body Shell
-
3.1 - check all seals
-
3.2 - check cylinder mounts top and bottom
-
3.3 - check general condition of shell
-
3.4 - check condition of all welds
-
Add media
4.0 Sucker Fan
-
4.1 - check condition of fan cover
-
4.2 - check fan cover hinge points and bushes
-
4.3 - check fan seals
-
4.4 - check fan blades and their welds
-
4.5 - check fan rotation and alignment
-
4.6 - remove side cover and check bushes
-
4.7 - check condition of springs & rod arm
-
4.8 - check engine mounts
-
Add media
5.0 Sucker Engine
-
5.1 - check leaks in tank
-
5.2 - check engine mounts for suitability
-
5.3 - check condition of gurnie
-
5.4 - check condition of gun and wand
-
5.5 - check condition cover belt guard
-
Add media
6.0 Sucker Boom (if attached to top of body)
-
6.1 - check turret condition and welds
-
6.2 - check condition of bearings
-
6.3 - check area around turret flange and body
-
6.4 - check rubber boot
-
6.5 - check spring and their retainers
-
6.6 - check hold down point of boom
-
6.7 - check general condition if boom
-
6.8 - check hose condition attached to boom
-
Add media
Defect Log
-
Defects
By signing this checklist you acknowledge that you have carried out the above inspections
-
I certify that the described plant is to the manufacturer's specifications and is being serviced and maintained by competent personnel to the manufacturer's recommendations
-
Add signature
