Title Page
-
Conducted on
-
Inspected by
-
Signature
Line 4 Base Checks
Base of 4 Checks
Break Blocks:
-
Bump stops: secure and not spinning, cracks (no bigger than 2cm)
-
Indicate which bumper, where
-
Wear blocks: running smoothly and wear is no less than 2mm from the edge of the break block
-
Indicate Line + L/R
-
Nuts & bolts: secure, and not spinning
-
Indicate where
-
Shackle Tight
-
Indicate Line + L/R
-
Redirection line: attachment is secure, knots are secure and line is in good condition,
-
Show wear
Redirection line:
-
Maintains tension
-
If No, upload photo
-
Attachment points are secure and knots are tight
-
Pulleys running smoothly
-
If No, indicate which pulley you think might not be working
-
3:1 system - 3 clear lines, not caught on anything, tangled etc
-
Attached Maillons and webbings secure and in good condition
Springs:
-
Springs all secured together
-
Spring pads secured to springs
-
Spring bank reset
-
Add media
End of Cable Cone: assess the resin within the cone to ensure cable security
-
Cable fibers visible or poking out of resin is what we are looking for, If there is fiber retraction within the resin, sunken pockets this indicates cable slippage
-
Add media
-
Hardware: Check bolts, nuts, cotter pins, cable clamps, and cable connection points
Structure:
-
Structure: Check anchor bolts for tightness
-
Please state why
-
Anchor Rods: Shake, listen for rattling or feeling of any looseness (indicates loose bolt)
-
Indicate which bolt, where
-
Hardware: Check bolts, nuts, cotter pins, and cable connection points
-
Cables: Look for damage, duress, fraying, corrosion, trees or branches on lines
-
Cable Tension: Look for slack cables (indicates nonequalization)
-
Uneven tensions
Zip Stop:
-
Container: for damage, loose fittings, pins are secure and nuts holding zipstop to structure are tight
-
Webbing: Pull out in it's entirety, check both sides for wear, tear, fuzziness, loose threads etc
-
Add media
FINAL CHECK (Photo) BEFORE YOU WALK AWAY FROM THE BASE OF LINE 4
-
ENSURE decks are clear, ladder is stored, breaks are reset, redirection line is not crossed, tangled or wrapped around the cable, springs are reset
Line 4 Top Checks
Top of line:
-
Structure: Check anchor bolts for tightness
-
Please state why
-
Anchor Rods: Shake, listen for rattling or feeling of any looseness (indicates loose bolt)
-
Indicate which bolt, where
-
Hardware: Check bolts, nuts, cotter pins, and cable connection points
-
Cables: Look for damage, duress, fraying, corrosion, trees or branches on lines
-
Cable Tension: Look for slack cables (indicates nonequalization)
-
Uneven tensions
-
Platform: Ensure structural integrity and cleanliness (no structural deformities or tripping hazards etc.)
Launchers: Are tensioned, retracts well and all bolts are present and secure
-
Adequately tensioned (reset into a horizontal position on their own)
-
Photo required
Place Restraint lanyards onto restraint cable:
-
Ensuring Maillons are facing away from the deck, gravity loaded and tight (green, orange, green), Clip to gate or deck to avoid damage
Place Trolley Tethers:
-
Place behind launcher (larksfoot attatchment)
-
Finally, ensure all safety checks are complete, 3 forms of attachment to the trolley, radio partner/Supervisor, to inform/get clearance to fly. Ensure both lines (FL&R) have been flown by guides before guests ride.