MOULD INSPECTION REPORT - LION

• REPORT NUMBER

• PROJECT

• CONTAINER

• Data

  Date

MOLD IDENTIFICATION

• Part Identification

• Mold Photos

  Media

2. INSPECTION ITENS

• Appearance Method Visual

• 1. Visual surface aspect approved? - (Visual)

  OK

  Ñ OK

• 2. Dust particles on the gel coat are not allowed. - (Visual)

  OK

  Ñ OK

• 3. No pinhole, crack, deformation, bubble, scratch, etc. - (Visual)

  OK

  Ñ OK

• 4. Is the mold clean and polished? - (Visual)

  OK

  Ñ OK

• 5. Are the flanges free from delamination, damage and irregularities? - (Visual)

  OK

  Ñ OK

• 6.RTM rubber undamaged? - (Visual)

  OK

  Ñ OK

• 7. Injector nozzles correctly installed? - (Visual)

  OK

  Ñ OK

• 8. Are the cut lines correct and visible? There are areas of excess material on the edges of the parts that will be used for demolding. The surfaces must be wide enough to allow the insertion of the mold release tools. - (Visual)

  OK

  Ñ OK

• 9. Release angles (minimum 1 degree) - (3D REPORT)

  OK

  Ñ OK

• 10. Are guide pins for holes fixed installed? - (Visual)

  OK

  Ñ OK

Measuring Points

• 11. Flange width (170 mm - 200 mm) - (Caliper)

  OK

  Ñ OK

• 12. Surface gloss. ≥90 GU - (Gloss Meter)

  OK

  Ñ OK

• 13. Surface hardness ≥ 40 Barcol - (Durometer)

  OK

  Ñ OK

• 14. Vaccum Test - (Vacuometer)

  OK

  Ñ OK

Structure flame

• 15. Welding points approved (no flaws, cracks, lack of welding, etc.) - (Visual)

  OK

  Ñ OK

• 16. Approved frame paint to prevent oxidation - (Visual)

  OK

  Ñ OK

3. THICKNESS

• Specification (4,0 - 4,5 mm ) - Method = Caliper

• Point 1=

• Point 2=

• Point 3=

• Point 4=

• Point 5=

• Point 6=

• Point 7=

• Point 8=

• Point 9=

• Point 10=

HISTÓRICO DE REVISÃO DE CONTEÚDO

• Revisão N° A
  
  Elaborado por: Alberto Andrade
  Revisado por: Hebert Cardoso