OPERATIONS - CONSTRUCTION - Residential Rough-in Checklist

Parts ordered?

Plans printed?

Plans marked up?

Cabinet plans received?

Cabinet plans printed?

NBN delivery determined?

Antenna requirements determined?

Appliance spec received?

Walkthrough performed?

Revised quote approved?

Have floor plan and cabinet elevations been cross referenced?

Internal sub-board location determined?

Island bench marked out by builder?

Floor marked out with measurements ?

Patch panel location determined?

Manhole location determined?

Nail brackets installed?

All support noggins installed?

Noggins and top plates drilled out?

All dedicated circuits run?

All Power feeds run back to board?

All GPO’s run?

External GPO’s run?

Island bench power feed run?

Any lighting in island bench?

Check wet area clearances

Check GPO’s don’t fall on tile edge if not fully tiled walls

Check all above bench heights are 150mm AB taking into account FFH (unless otherwise noted)

Lighting feed ANE’s installed back to board?

Lighting circuit ANE’s looped?

All switch actives installed?

All LED cabling run?

All 2-way and 3-way wiring run? <br>

All pendants on a nail?

All ceiling fans on a nail?

Exhaust fans clearances checked?

Exhaust fan ducts run?

Range hood duct installed?

Are all smoke alarms run?

All data points run?

All TV points run? <br>

Antenna installed out of site from front of building?

Intercom cabling run?

All lighting tails labelled?

Plans checked off?

Plans marked up with measurements?

Photos of wet areas?

Worksite swept and rubbish in skip?