Title Page
-
Project Name and/or Job Number
-
Site Address
-
Conducted on
-
Roof Section/s
-
Safety Mesh Installer
-
Handrail Installer
-
Document No.
Form
-
MESH CRITERIA - Does the safety mesh materials comply with the performance requirements of AS/NZS 4389:2015 / HB39?
-
PLACEMENT OF MESH - Has the safety mesh been installed in accordance with AS/NZS 4389:2015 / HB39? If not, has the safety mesh been placed in accordance with manufacture's recommendations?
-
ARE THE PURLINS LESS THAN 1200MM? Is the mesh is lapped minimum 150mm?
-
ARE THE PURLINS 1200-2199MM AND THE MESH LAP MINIMUM 150MM AND SIDE LAP FASTENED WITH 2MM RING FASTENER OR TWITCHED AT 900MM MAX CENTRES BETWEEN EACH PURLIN
-
DO THE END JOINS COMPLY WITH THE FOLLOWING REQUIREMENTS? Two transverse wires are placed together. The longitudinal tail wires (approx 300mm long) are tied around each other, one being twisted four times around the main portion of the same wire, the other longitudinal wire twisted once around the main portion of the same wire then FOUR times around the two transverse wires.
-
ROOF GUARD RAIL INSTALLED?
-
IF USING GUARD RAIL SYSTEM, IS IT APPROPRIATE FOR THE TYPE OF ROOF?
-
IS GUARD RAIL INSTALLED AS PER MANUFACTURERS REQUIREMENTS
-
ROOF ACCESS GATE/S INSTALLED?
-
The information above has been received and sighted and as such access is granted to the following section/s of roof: (use grid lines or attach a marked up plan below):
-
Attach marked up plans OR Photos to show approved areas
-
HKH ROOFING
-
Position
-
BUILDER
-
Position
