Title Page
-
Site conducted
-
Conducted on
-
Prepared by
-
Location
-
Site Code XXXX
General Site
-
XXXX_S01
-
General site overview of shelter and tower, plus surrounding buildings (taken from standing position showing ground and about 20m either side of antenna). Must be taken postscaffolding removal
-
XXXX_S02
-
Compound showing any colocated outdoor cabinets / shelters / towers
-
XXXX_S03
-
Site Access Main entrance door or first gate off road
-
XXXX_S04
-
Site Access Internal entry door(s) and stairway(s) or subsequent access track gates or track intersections
-
XXXX_S05
-
Site Access Building / Rooftop walkways
-
XXXX_S06
-
Site Access other (e.g. "4WD only" or other sitespecific signs)
-
XXXX_S08
-
Signage yellow PPE sign at entrance to site, or on shelter or cabinet door, showing site code
-
XXXX_S09
-
Signage RF Hazard tower; mast; streetlight pole; rooftop (wall or parapet)
-
XXXX_S10
-
Roof exclusion zones showing roof markings / signage / chain barriers
Housing (Shelter / Cabinet / Room)
-
XXXX_H01
-
Outdoor cabinet(s) wide shot of all cabinets with doors closed
-
XXXX_H02
-
Outdoor cabinet(s) – separate photos for each individual cabinet, with the door open showing installed units and associated cabling
-
XXXX_H03
-
Shelter / Room Inside LHS corner inside door, photo to include floor and ceiling
-
XXXX_H04
-
Shelter / Room Inside LHS far corner from door, photo to include floor and ceiling
-
XXXX_H05
-
Shelter / Room Inisde RHS far corner from door, photo to include floor and ceiling
-
XXXX_H06
-
Shelter / Room Inisde RHS corner inside door, photo to include floor and ceiling
-
XXXX_H07
-
Shelter / Room Inside nonstandard (e.g. equipment room with a different shape)
-
XXXX_H08
-
Cable entry from inside (floor or wall some sites may have both)
-
XXXX_H09
-
CHORUS ONLY Cable entry from outside
-
XXXX_H20
-
CHORUS ONLY Panoramic view of entire equipment room
-
XXXX_H09
-
Shelter / Outdoor Cabinet Outside front Close Up
-
XXXX_H10
-
Shelter / Outdoor Cabinet Outside back Close Up
-
XXXX_H11
-
Shelter / Outdoor Cabinet Outside left side Close Up
-
XXXX_H12
-
Shelter / Outdoor Cabinet Outside right side Close Up
-
XXXX_H13
-
Shelter / Outdoor Cabinet Roof Close Up
-
XXXX_H14
-
Air Con Unit Outdoor
-
XXXX_H15
-
Air Con Unit Indoor
-
XXXX_H16
-
Fresh Air fan indoor
-
XXXX_H17
-
Fresh Air fan outdoor
-
XXXX_H18
-
Supervisory Close Up
Twr / Ant
-
XXXX_T01_S_Y
-
Antenna close up showing labelling
-
XXXX_T02_S_Y
-
RRU/ RRH plus mount close up (unit mounted individually) showing labelling
-
XXXX_T03_S_Y
-
RRU / RRH plus mount close up (units mounted in a group) showing labelling
-
XXXX_T04_S_Y
-
Building & Tower / Antennas / RRU / RRH wide shot of each sector
-
XXXX_T05_S_Y
-
TMA (showing cabling and labelling)
-
XXXX_T06_S_Y
-
Outdoor W850 Filter installed (showing cabling and labelling)
-
XXXX_T07_S_Y
-
Outdoor Diplexer / Combiner installed (showing cabling and labelling)
-
XXXX_T08_S_Y
-
Bulkhead at top of the tower showing the DC leads & fibre leads
-
XXXX_T09
-
Tower head
-
XXXX_T10
-
Tower whole
-
XXXX_T11
-
Inside of tower base showing the cable ducts / earthing
-
XXXX_T12_S_Y
-
Inside of tower base showing ducts
-
XXXX_T13
-
GPS Antenna (showing location e.g. exchange rooftop, tower, shelter)
-
XXXX_T14_S_Y
-
Sector coverage (ideally taken looking over the top of the antenna). Technology ID required only if there are multiple antennas on a sector
Equipment / Base station
-
XXXX_T15
-
Existing tower foundations / anchor blocks
-
XXXX_E01
-
Indoor cabinet door open (3900L, 37U)
-
XXXX_E02_Y
-
Front of cabinet door closed
-
XXXX_E03_Y
-
Close up BBU/d2u/d4u (showing Labelling, earthing, DC, Fibres)
-
XXXX_E04_S_Y
-
RRU/ RRH plus mount close up
-
XXXX_E05_Y
-
RRU / RRH plus mount group close up
-
XXXX_E06_S_Y
-
W850 Filter installed (showing cabling and labelling)
-
XXXX_E07_S_Y
-
Indoor Diplexer / Combiner installed (showing cabling and labelling)
-
XXXX_E08
-
First DCDU on site
-
XXXX_E08
-
Each additional DCDU on site
-
XXXX_E09
-
First MTP tray / fibre patch panel on site
-
XXXX_E09
-
Each additional MTP tray / fibre patch panel on site
Pwr Systems
-
XXXX_P01
-
Indoor cabinet whole cabinet view showing number of rectifiers and battery banks installed (note: do not remove grill just to take this photo)
-
XXXX_P02
-
Indoor/Outdoor cabinet door closed Rectifier and/or Batteries installed whole cabinet view
-
XXXX_P03
-
DC power system controller (Close Up)
-
XXXX_P04
-
DC Circuit Breaker Panel (in both Eaton and 37U cabinets)
-
XXXX_P05
-
DC Circuit breaker panel Legend Sheet in Eaton cabinet (label card must match circuit breakers)
-
XXXX_P06
-
Battery String(s)
-
XXXX_P07
-
AC distribution cabinet
-
XXXX_P08
-
AC power meter and Metering Installation Certificate (needed for asbuilts only on new sites)
-
XXXX_P09_Before
-
Load current in Eaton rectifier cabinet before integration
-
XXXX_P09_After
-
Load current in Eaton rectifier cabinet after integration
-
XXXX_P10
-
All cabinets close up of batteries to show amp/hours rating. Take this photo through the front grill of indoor cabinets unless this has already been removed
-
XXXX_P11
-
Earth resistivity label
-
XXXX_P12
-
New batteries Photo of multimeter showing battery string voltage prior to turning on the breaker
-
XXXX_P13
-
CHORUS ONLY Photo of AC distribution board feeding the mobile site
-
XXXX_P14
-
CHORUS ONLY Photo of AC breaker feeding the mobile site
Backhaul
-
XXXX_B01
-
DMR/eDMR dish Close Up (multiple photos also showing radio head behind dish if applicable)
-
XXXX_B02
-
DMR/eDMR indoor unit
Fire
-
XXXX_F01
-
FirePro Unit installation Utility Cabinet (where site in public land or road reserve)
-
XXXX_F02
-
FirePro Unit installation Tower (where site in public land or road reserve)
-
XXXX_F03
-
Fire Stopping (Building Penetrations, Utility Cabinet, Feeder Ducts)
Civils and Structural
-
XXXX_C01_PrePour
-
Pre pour and after photo of any changes to the foundations
-
XXXX_C02
-
Before and after photo of any new steelwork or strengthening on the tower (hold down bolts, flanges, mounts, headframes, guy wires and hardware)
-
XXXX_C03
-
Guy wire photo with ruler/caliper showing the actual size of the new guy wires
-
XXXX_C04
-
Tagged Anchor Points
Latchway
-
XXXX_L01
-
Top Anchor
-
XXXX_L02
-
Bottom Tensioner
-
XXXX_L03
-
Tag
-
XXXX_L04
-
View looking up tower shaft with Latchway completed