Title Page

  • Conducted on

  • Prepared by

  • Location

Planning before the site visit - (action any red flags before attending site)

  • Was the premises built AFTER Dec 2003?

  • It is a legal requirement to contact Safework NSW regarding the demolitian or refurbishment. Email them on adu@workcover.nsw.gov.au

ASBESTOS

  • Have you confirmed that there is no asbestos on site?

  • Has the type of asbestos been identified by an hygienist or licensed asbestos contractor?

  • Do not proceed until the type and quantity have been assessed by a licensed asbestos contractor.

  • When asbestos may be present, PPE requirements are P2 or N95 disposable mask or half-face respirator, disposable overalls, face and hand wipes, boot covers or gumboots.

STRUCTURAL ASSESSMENT

  • Was an engineer's assessment required and obtained?

  • Were trades engaged on the basis of this assessment?

HAZARDOUS or FLAMMABLE CHEMICALS

  • Were there any commercial quantities of hazardous or flammable chemicals used on site?

  • Arrange for a qualified specialist (e.g. EPA Engineer or Hygienist) to provide advice on removal and remediation.

  • Have you confirmed the correct PPE that will be required for the site visit, considering the type of chemicals required?

  • Check with fire department or the Chemical Safety Data Sheet for advice

BIOLOGICAL HAZARDS -

  • Has there been contamination from a death or human matter, animal carcass or large quantities of spoiled food?

  • Has the affected area been biologically cleaned?

  • If attending site before cleaning it is essential that you wear the following PPE while onsite:
    P2 or N95 respirator, disposable overalls, face and hand wipes, boot covers or gumboots.

WATER DAMAGED PREMISES

  • Has the category of water contamination been determined?

  • Arrange for site assessment, appropriate cleanup and make safe

  • Was a hygienist assessment required?

  • Has the hygienist provided their assessment?

  • Has the appropriate level of make safe been completed?

  • Have trades confirmed that the make safe has been completed and it is safe to attend site?

  • Do I have the correct PPE for the site assessment? (Show covers / Gum Boots, P2 respirator, Gloves, hand sanitiser)

STEP BACK RISK ASSESSMENT (ONSITE)

DYNAMIC RISK ASSESSMENT - SCAN THE AREA CAREFULLY AS YOU ENTER

  • Is the area stripped and dried in line with your instructions?

  • Are there any electrical, biological or chemical hazards present?

  • STOP - Scan the site - Is it safe to enter? If not - DON'T

  • Has the floor area been cleared of trip & slip hazards?

  • Are there any protrusions from the ceiling which are a hazard?

  • Has the electricity been turned off?

  • Are there any electrical hazards in the area?

  • Am I wearing the correct PPE for the situation ? (e.g. P2 Mask, shoe covers or gumboots, hand sanitiser, disposable overalls, etc)

The templates available in our Public Library have been created by our customers and employees to help get you started using SafetyCulture's solutions. The templates are intended to be used as hypothetical examples only and should not be used as a substitute for professional advice. You should seek your own professional advice to determine if the use of a template is permissible in your workplace or jurisdiction. You should independently determine whether the template is suitable for your circumstances.