ASL Monthly Biomass PPM V2.1

Is the heat exchanger clean and are all tubes unobstructed?

Is the furnace clean?

Are the furnace bricks in good condition?

Is the temperature probe clear?

Are the firebed castings in good condition?

Is it clear under the firebed?

Is the moving grate operating?

Does the firebed look in good condition?

Are the ash bins clean?

Are the ash bin seals ok?

Are the Biffa bins full?

Have Biffa been notified to empty bins?

Does ash extraction auger operate?

Does ash transport auger operate?

Is the Ash Auger cooling pump operating?

Are all of the bearings ok?

Are rotary valves leaking?

Does the compressor operate?

Do all soot valves operate?

Are there any air leaks from the soot cleaning system?

Are ID fan belts in good condition and tight?

Are there spare belts on site?

Are the motor or bearings excessively noisy?

Is the flue in good condition?

Is depression manometer clear and functioning correctly?

Does Primary pump 1 operate?

Does Primary pump 2 operate?

Does secondary pump 1 operate?

Does secondary pump 2 operate?

Do all pump invertors operate?

Are any of the pumps leaking?

Are all 3 fuel augers operating correctly?

Fuel silo Auger bearing satisfactory?

Fuel transport auger bearing satisfactory?

Proximity sensor located and operating?

Are all fuel system motors in good condition?

Is the Fuocomatic gearbox secure with no movement?

Does the fire damper actuator operate?

Does the Fuocomatic burn back thermostat operate?

Is the dosing valve leaking or letting by?

Is Carel unit operating correctly?

Is primary fan motor operating correctly and in good condition?

Is primary air actuator operating and set correctly?

Is secondary fan motor operating correctly and in good condition?

Is secondary air actuator operating and set correctly?

Is Lambda probe operating correctly?

Does control panel isolator operate?

Is control panel in good condition?

Do control panel cooling fans operate?

Are control panel ventilation grills clear?

Are all overloads fitted in the control panel?

Is touchscreen operating?

Are all panel lights operational?

Is all pipework and plant in good condition?

Are there any leaks in the skid?

Is the pressurisation unit operating?

Pressure vessel set to correct pressure? (quarterly check)

Heating system pressure satisfactory

Are the safety valves letting by?

Are all the lights in the plant room working?

Are all gearbox oil levels satisfactory?

Is the hydraulic oil level satisfactory for moving grate?

Are there any oil leaks?

Is fuel store sealed in plant room?

Is the floor clean

Are plant room ventilation grills clear?

Is the plantroom clean and free from dust and pellets?

Is the fire plaque fitted to the outside of the skid?

Is the heat meter working?

Is the remote outstation (IQ unit) working

Have you notified Smarthub?

Are there any other issues?