Title Page
-
Job Number
-
Conducted on
-
Prepared by
-
Location
-
Do welders have a copy of their welding certs with them?
-
Do welders have a copy of the applicable weld procedure?
-
Is the inspector present?
-
Have you verified pipe grade, wall thickness and size with the correct welding procedure?
-
Were the Foreman, Inspector and Welder involved in verification?
-
Have you verified pipe and fittings match the drawings? (Wall thickness, grade, size all match?)
-
Are the bevels buffed back 1 inch inside and out?
-
Does what you're building match the drawings?
-
Why doesn't what you are building match? Should a change be issued?
-
VERIFY: Have you confirmed an RFI has been turned in for the change?
-
Does the weld require pre-heat?
-
Do welder helpers have the proper temp sticks on them to verify pre-heat?
-
Are only applicable welding rods in bucket?
-
Are you installing a valve?
-
Did you place weld shield inside the valve, or has the valve already been pupped out?
-
Did you verify the weld shield has been cleared out?
-
Are you using Lo-Hi Rods?
-
Have Lo-Hi rods been stored/handled correctly?
-
Have you opened a new can or are using a rod oven?
-
Are splatter mats utilized to prevent coating damage?
-
Is grounding lead properly secured so it will not come off the pipe?
