Brush Cutter/Line TrimmerPre Start check List

• Site conducted

  Select

• Conducted on

  Date

• Prepared by

• Location
  Address

• PRE-OPERATIONAL SAFETY CHECKS

  Date

• Names of participants

• DO NOT use this machine unless a teacher has instructed <br>you in its safe use and operation and has given permission. Do you have permission from the teacher or supervisor?<br>

  Yes

  No

  N/A

• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.

• Inspect fuel lines, tank, and area around carburetor for fuel leaks. Do not operate unit if leaks are found.

• Ensure that all guards are fitted, secure and functional.

  Compliant

  Non-Compliant

  N/A

• Ensure the blade unit has a debris shield, has either a bar handle or a U-handle, and is suspended from a shoulder harness.

  Compliant

  Non-Compliant

  N/A

• Select the correct cutting tool for the task to be undertaken - refer to manufacturer's specification.

• Load the nylon line cutting head only with nylon trimmer line of the proper diameter.

• Do not operate if the line cutter is missing.

  Safe

  At Risk

  N/A

• Before operating unit, thoroughly inspect blades for damage and cracks.

• When operating the unit with a blade, ensure the blade is attached to the unit as designed, such as with a locknut and cotter pin, and with the teeth pointing in the direction the blade head rotates.

• Faulty equipment must not be used. Report suspect machinery immediately.

  Safe

  At Risk

  N/A

• OPERATIONAL SAFETY CHECKS

• Watch especially for ejected material and ensure that no person or animal is endangered when operating.

• Adjust the handle/s to a position for comfort and good balance.

• When starting, ensure the machine is in a clear area so the line or blade cannot contact the ground or any other obstruction.

• The muffler side of the engine should be away from your body to avoid burns.

• Maintain footing and balance at all times. Do not work on slippery, uneven or unstable surfaces.

• Maintain a straight wrist position. Avoid using your wrist in a bent, extended or twisted position for extended periods.

• Always keep both hands on the control handles. Do not operate one-handed.

• Do not raise the line or blade head above knee height.

• Keep machine clear of fences, wires, posts, rocks, etc. to prevent kick out and cutter head damage.

• Shut down immediately if the unit starts to shake or vibrate.

• After shutting down engine, keep fingers and feet away from cutting line or blade until all rotation stops.

• Disconnect spark plug wire before you work on the unit or leave it unattended.

• Take extreme caution when refuelling to avoid igniting fuel on hot exhaust or engine.

• HOUSEKEEPING

• Remove any foreign material from engine, cutting tool and guards.

• Keep the work area and implement shed in a clean and tidy condition.

• POTENTIAL HAZARDS

• The blade can push, pull or kick out

• Noise

• Entanglement

• Ejected materials

• Yes

  No

  N/A

Signature of participants

• Participant 1

  Sign

• Participant 2

  Sign

• Participant 3

  Sign