Information
-
Work Order #
-
Client / Site
-
Conducted on
-
Prepared by
Screening Question
-
Is there any areas at your home that feel to cold or to hot?
-
What are of the home?
-
Does anyone that lives here suffers from seasonal allergies or asthma?
At what temperature do you usually have the thermostat set to?
-
On average, what's your electrical bill during this time of the year?
-
Any repairs done to the system?
-
What repairs where done to the system?
-
How often do you change the filters?
-
Has the system been performing properly?
-
How is it malfunctioning?
System Inspection
Controller
-
Thermostat Location
-
Does the cooling cycle sets on?
-
Does the heating cycle sets on?
-
Does the blower cycle sets on?
-
Is it wire properly?
-
Are the wire properly insulated from the wall?
Filter
-
Filter#1 Size?
-
Filter#1 Qty?
-
Filter#2 Size?
-
Filter#2 Qty?
-
Filter#3 Size?
-
Filter#3 Qty?
Indoor Air Quality
-
Are the Supply and Return Grills properly Insulated?
-
Are the Supply and Return Grills clean?
-
Is the attic ladder in good conditions?
-
Is there enough insulation in the attic? (Does it cover the beams)
-
Do we have enough walkway around the system? (2ft around)
-
Are the plenums properly insulated?
-
Are the plenums hanged properly?
-
Does the system have a UV Light?
-
What Brand, Model and Serial?
-
Does the home Carbon Monoxide Detector?
-
Does the attic has a Attic Tent?
-
Is it properly insulated? (calk and staples every 6in)
Ducts
-
Are the ducts collars properly insulated?
-
Are the ducts hanged every 12in?
-
Are the ducts properly hanged? (best route and not hanging)
Indoor Equipment
-
Coil Image
-
Coil Tag
-
Furnace/Air Handler Image
-
Furnace/Air Handler Tag
Heating Cycle
-
Type Of Heating
Supply Temperature
Temperature Difference
-
Did it pass the gas leak detection test?
-
Are the Heat strips/ Heat Exchanger in good condition?
-
Are the Sequencers in good condition?
-
Is the Ignition Control in good condition?
-
Is the Gas Valve in good condition?
-
Is the Hot Surface Ignitor in good condition?
-
Is the Pressure Switch in good condition?
-
Is the Vent Pipe in good condition?
-
is the Inducer Motor working properly?
-
Inducer Motor Rating
-
Is the Flame Sensor in good condition?
-
If a gas system, does it have a properly installed drip leg?
Cooling Cycle (Indoor System)
-
Supply Temp
Temperature Difference
-
Is the Disconnect Switch working properly?
-
Is the secondary pan in good conditions?
-
Did the float switch past the safety test?
-
Did the In-Line Switch past the safety test?
-
Did the Jones Valve past the safety test?
-
Is the Main Drain Line insulated?
-
Does the Main Drain Line have at least a 35Degree slope?
-
Is the Emergency Drain Line Insulated?
-
Does the Emergency Drain Line has at least a 35 Degree slope?
-
Is the TXV Set properly, insulated and strapped?
-
Copper Line Insulated?
-
Is the Thermostat Wire properly ran and connected?
-
Is the Blower Motor Running properly?
-
Is the Blower Motor Clean?
-
Blower Motor Rating
-
Is the Door Switch functional?
-
Is the Contactor working properly?
-
Is the capacitor Capacitor working properly?
-
Capacitor Rating
-
Is the Transformer working properly?
-
Is the Circuit board working properly?
-
Is the Coil Clean?
Outdoor Equipment
-
Condenser
-
Condenser Tag
Cooling Cycle (Outdoor System)
-
Refrigerant Type
-
Is the Service Disconnect properly installed?
-
Is the Electrical Whip properly connected?
-
Is the Serge Protector properly installed?
-
Does the UV Armaflex looks in good conditions?
-
Is the condenser properly level?
-
Is the Condenser Pad in good conditions?
-
Is the Condenser Coil Clean?
-
Is the Contactor working properly?
-
Is the Capacitor working properly?
-
Capacitor Rating
-
Is the Start Assist working properly?
-
Is the Circuit Board working properly?
-
Is the Fan Blade in good conditions?
-
Is the Fan Motor working properly?
-
Fan Motor Rating
-
Is the Compressor working properly?
-
Compressor Rating
-
Does the line have Locking Caps?