Page 1: Initial questions
-
Conducted on
-
Client
-
Prepared by
-
Location
-
Make
-
Unit #
-
Refrigerant type
A/C inspection
-
Thermostat in working conditions
-
Inspect all wiring and electrical connections
-
Check blower belt wear, tension
-
Check voltage & Amperage draw
-
inspect compressor contactors
-
Does unit require maintenance
-
Visually inspect compressor
-
Test capacitor
-
Check Pressure switch
-
Replaced air filter
-
Check refrigerant (freon) levels and advise if adjustments necessary.
-
Check pressure switch cut-out setting
-
Condition of condenser coil
-
Condition of suction line insulation
-
Chemically wash condenser coil
-
Any signs of oil on condenser
-
Inspect evaporator coil
-
Inspect condensate drain pan
-
Inspect condensate secondary drain pan
-
Inspect Air ducts for leaks
-
Lubricate parts as needed.
-
Inspect disconnect
-
Test Unit in cooling mode
-
Inspect duct detectors
-
Check condensate drain lines
Gas Furnace
-
Inspect and adjust Thermostat
-
Check to make sure furnace/heat comes on
-
inspect blower motor
-
Inspect flu for rust & corrosion
-
Check Electronic spark
-
Inspect all wiring and connections and controls
-
Inspect Heat exchangers for cracks, soot, & rust
-
Check for gas leaks (furnace only)
-
Test all safety shut off
-
Test draft motor