L&O ROUGH IN AUDIT 2024

Pre site safety checklist completed

Circuits arranged to suit reasonable maximum demand

NBN GPO wired in to WSC or TP (Carlisle)

TV roof coils located at manhole and link ran to WSC

Maintained separation of structured cables from electrical cables

All data and comms pipe roughed in (including waps)

Cat cable labeled at each end what data point it is.

Alarm roughed in and each cable labeled at alarm panel.

Keyfob module roughed into garage door motor location

Feeds/mains in switch boards

Sub board location as per plan

Feeds/mains segregated from gas, water pipes and structured cabling

Measurement for sub board noted on plan.

Earth bond connected and zinc spray

Switchboard cable entry 'slide & cover' reinstalled.

Switchboard cable entry point fire guarded.

Pole fillers reinstalled

Correct cable sizes used for AC and Sep circuits

N/C measurements on plan

All brackets installed

Client/plan specific measurements followed.

All items as per plan

All heights as per plan

GPOs in wet areas at minimum heights & minimum clearance.

WM GPO as per builder/plan/specs/regs

Bathroom/ensuite GPO loop measurements on plan

Cables clear of return air void

Holes drilled in brace board, maximum 100mm

Holes drilled in walls and top plates minimum 300 apart

Holes drilled in walls and top plates minimum 300 apart. More than 1.

Holes drilled in walls and top plates minimum 300 apart. 3 or more.

Holes 300 from bracing

Holes 300 from bracing. More than 1.

Holes 300 from bracing. 3 or more.

25mm segregation from pipes.

25mm segregation from pipes. More than 1.

25mm segregation from pipes. 3 or more.

Oven & cook top wired correctly. Upright/wall oven/induction.

Under bench power ran in correct slab conduit & corrugated conduit.

Kitchen measurements correct and noted on plan

All switches stripped up and earths soldered

All light measurements on plan

Light measurements not obstructed by building materials or other services

Alfresco/balcony/porch measurements off of bricks/cladding

Kitchen strip lighting GPO provisions ran in 2.5mm

Kitchen strip light/under cupboard lights roughed in correctly. Location and accessibility of cables.

2 ways/3 ways ran correctly

Smoke detector locations as per regs

Smoke detectors interconnected

Cables securely supported on trusses

Cables securely supported on trusses, multiple.

Switching of lights roughed in as per plan

In-roof JB provisions fit off at rough in. Noted on plan.

Pendant and fan nogs installed

Plug bases fit off

Correct exhaust fan measurements

Exhaust fans clear of obstructions

Roof work in correct location/s

Roof work locations marked on plan

Exhaust fans and range hood ducted

Holes drilled 300mm apart in Joists

Holes drilled 300mm apart in Joists. More than 1.

Holes drilled 300mm apart in Joists. More than 3.

J/B's installed on single ends of Evap, Heater and Light coils.

Externals drilled out/poked

External heights, as per plan.

External heights, as per plan. Multiple.

External cables clearly labelled with height and location

External cables clearly labelled with height and location. Multiple

Electrical items clear of down pipes

Electrical items clear of down pipes. Multiple.

HWS GPO in correct location

AC isolator/s in correct location

External Vent and Duct locations marked on plan with a measurement for double storey homes

Electrical items 1000mm clear of gas meter

NBN conduits line up

External items taped to a nail in location to be brought through cladding with note labeled on cable (please pull through at this height)

Site has been swept up, all rubbish in bin

Detailed unfinished report completed

Moved items noted on unfinished report