Nautical Roofing 2015 SAFETY MESH HANDOVER and ROOF ACCESS CERTIFICATE

• Project Name and/or NR Job Number

• Site Address

• Conducted on

  Date

• Roof Section/s

• Safety Mesh Installer

• Person Inspecting Mesh/Rail

• Document No.

To be completed by the site supervisor (Diagrams for installation available on MSDS in safety folder)

• MESH CRITERIA - Does the safety mesh materials comply with the performance requirements of AS/NZS 4389:2015 / HB39?

  Yes

  No

  N/A

• PLACEMENT OF MESH - Has the safety mesh been installed in accordance with AS/NZS 4389:2015 / HB39? If not, has the safety mesh been placed in accordance with manufacture's recommendations?

  Yes

  No

  N/A

• ARE THE PURLINS LESS THAN 1200MM? Is the mesh is lapped minimum 150mm?

  Yes

  No

  N/A

• ARE THE PURLINS 1200-2199MM AND THE MESH LAP MINIMUM 150MM AND SIDE LAP FASTENED WITH 2MM RING FASTENER AT 900MM MAX CENTRES BETWEEN EACH PURLIN

  Yes

  No

  N/A

• DO THE END JOINS COMPLY WITH THE FOLLOWING REQUIREMENTS? Two transverse wires are placed together. The longitudinal tail wires (approx 300mm long) are tied around each other, one being twisted four times around the main portion of the same wire, the other longitudinal wire twisted once around the main portion of the same wire then FOUR times around the two transverse wires.

  Yes

  No

  N/A

• ROOF GUARD RAIL INSTALLED and HANDOVER CERTIFICATE RECEIVED?

  Yes

  No

  N/A

• IF USING GUARD RAIL SYSTEM, IS IT APPROPRIATE FOR THE TYPE OF ROOF?

  Yes

  No

  N/A

• ROOF ACCESS GATE/S INSTALLED?

  Yes

  No

  N/A

• The information above has been received and sighted and as such access is granted to the following section/s of roof: (use grid lines or attach a marked up plan below):

• Attach marked up plans to show approved areas

  Media

• Add signature

  Sign

• Position

  Site Supervisor

  Safety Advisor