Title Page
-
Site conducted
-
Conducted on
-
Prepared by
-
Location
-
Which machine are you using (example: HD Threader 1, 2, 3, or 4)
-
Work Shift (Day or Night)
1. Safety Check
-
Check the oil in the reservoir is properly filled.
-
Make sure it is at the correct table height.
-
Check pronged locking plug are connected.
-
Check the bar stop handle for proper functioning (Lever for run process)
-
Check to make sure the head of the threader is rotating in the direction indicated by the red arrow on the hood.
-
Check for loose bolts and wear.
-
Make sure all metal shavings is put in the proper metal shavings drain buckets
-
Confirm that the bar size selected is correct.
-
Make sure all threader accessories on the shelf are organized and not on the ground
-
Check the teeth/chasers by running a test bar
-
Check for oil spills around your area
-
Make sure all old/used rags are placed in waste disposable can.
-
Check all Emergency Shut off switches on the threader are working including the door.
-
Are the tables and racks in good working condition
-
Is the vice in good working condition
-
Do you have all the correct tools and are they in good working condition
-
Specific Machine and Instructions book is available at my station
-
Is your work area free of obstacles and obstructions
-
Is the Drip Pans/Secondary Containment's free of oil, rags, and debris.
-
Are are pins to the racks off of the floor and in proper locations
-
Are spill kits available and stocked
-
Do the absorbent pads need to be replaced due to oil, spill, or debris? If so, replace them.
-
Check for any missing or loose guards
-
All Electrical Panals have a clear access and no obstructions
-
Are all No-Touch available and in good condition
Pictures
-
Pictures of any issues found (Be sure to fill out Maintenace Request Forms when applicable and attach phote)
2. Preventative Maintenance and Safety Check
-
Check all electrical cords and outlets for defects and plugged in correctly
-
Check for normal operation before threading any steel
-
Have you wiped down your machine (Example: Grease, Oil, etc.)
-
Check your tools for wear or deformation (Example: Vice/Pipe Wrench, Allen Wrenches, Specialty Tools, etc.)
-
Visually inspect all mechanical parts for damage and components are functioning properly.
-
Check all labels on HS Threader and chemical storage area - replace labels if missing or worn out
-
Check hydraulic oil level for the vice. located on the left side of the machine.
Pictures
-
Pictures of all additional findings
SIGNATURE OF INSPECTORS:
-
My Pre-Flight Inspection is complete, and all findings have been reported to my immediate supervisor. I understand that bypassing any machine guarding or safety device will result in disciplinary action. All devices which are not functioning shall be locked out and tagged out of service.
-
Please print your name (Inspector)
