Title Page
-
Conducted on
-
Prepared by
-
Site Location
-
Inspection location
-
Client
-
Contractor
-
Scaffold Contractor
-
Can inspection be carried out safely
-
Any site specific Health and safety hazards
- Working at height
- Deep excavations
- Scaffolding
Inspection checklist
Foundations
-
Footings are on firm even ground
-
All base plates are in position
-
All sole boards / pads are in position
-
Footings have not been undermined by other works, plant, weather conditions etc.
Geometry
-
All standards /uprights are plumb
-
All standards / uprights are not jointed in the same bay
-
Standards / uprights are correctly spaced
-
Standards/uprights are all in good condition and not showing any signs of damage
-
Ledgers are all level
-
Ledger joints are staggered
-
Ledger joints are sufficiently tight
-
Ledgers and joints are all in good condition and not showing any signs of damage
-
Correct and sufficient ledger and facade bracing is in position
-
Bracing is sufficiently tight
-
Transoms/ putlogs are correctly spaced
-
Transoms / putlogs are sufficiently tight
-
Transoms/ putlogs have sufficient support
Fittings
-
Couplings are correctly fitted
-
No couplings are loose
-
Couplings are in good condition and not showing any signs of damage
-
Checkcouplers in place where appropriate
Working platforms
-
Boards are in good condition
-
Boarding is complete
-
No trap boards
-
Boarding adequately supported
-
Good housekeeping on working platform
-
Is the working platform the correct width for its intended use
Ties
-
Have the ties been installed with right angled load bearers
-
Have the correct number of ties been installed
-
All ties in place
-
All ties adequately tightly fitted
-
Have at least 5% ( min 3 ) of ring bolt ties been tested
-
Are the Rakers installed correctly
Protections
-
Double guardrails in position at correct height
-
Toe boards at correct height
-
Guard rails and toe boards tightly fitted
-
No guards or toe boards missing
-
Are brickguards in place
Ladders and access
-
Ladders in good condition
-
Ladders of correct length
-
Ladders tied safely
-
Is the ladder set at the correct angle
-
Is the ladder on a firm, level and stable ground base
-
External ladder - are gates fitted at each platform
-
Internal ladder - Are hatches fitted at each platform
-
Is staircase installed to the manufactures erection guidelines
-
Are landing areas cleared of obstructions
Loading
-
Are the standards tubes at the correct spacing for its intended use
-
Are loads on scaffold evenly distributed
-
Are materials stacked securely
Gin wheels
-
Identity number visible
-
Hook not moused
-
Check fittings in place
-
Within regulation distance
Completion of inspection
-
Signature