SDH POST FRAMING CHECKLIST

Check that no holes or notches are cut into the TGI’s after PME

Make sure all doors do not swing over switches

Confirm termite spray

Check for OSB in all chase tops and that they are sealed

Install tub studs at all showers and tub edges

Check all plumbing/mechanical/electrical penetrations

Ensure that T ply and insulation is installed behind tubs, showers, and any exterior wall area not accessible

Check the toilet locations center of wall closet 15 1/2 inches off of wall 15 inches off of the cabinet and tub

Check HVAC duct for kinks

Confirm utility meters are stubbed out minimum 3 feet apart

Make sure all holes are sealed to exterior, both roof and sheathing

Confirm office has scheduled all undergrounds

Confirm PME inspections passed

Check all joists for damage

Place all updated cut sheets and options in windows

Transition grills properly installed

Vents are not in the way of crown details

Check for nail plates

Make sure light fixtures on the stairs and hallways or 6’8” minimum

Make sure outlets are with in 12 feet of each other, 2 feet from counter brakes

Confirmed that all walls drilled more than 40% and non-load bearing walls 60% or more are supported

Confirm outlets are dropped in shadowbox areas

Check stair switches for clearance from rail

Confirm no studs are twisted or bowed (especially at electrical boxes)