Title Page
-
Site conducted
-
Conducted on
-
Prepared by
-
Location
External lighting.
-
Check for failed or flickering lamps or signs of deterioration.
- Yes
- No
- N/A
-
Measure the lighting levels using a Lux Level Meter and record the results in the notes section. Report any deficiencies and recommend appropriate action.
-
Check externally for security and signs of arcing or overheating. (Renew or re-fix as necessary)
- Good
- Fair
- Poor
- N/A
-
Check operation and compatibility with lamp.
- Pass
- Fail
- N/A
-
Check operation of all switches in relation to the outside lighting and signs.
- Pass
- Fail
- N/A
-
Check function and operation of any lighting control contactors.
- Pass
- Fail
- N/A
-
Ensure that lamp circuits operate at the correct times, both for normal operation and for extended on/off periods.
- Pass
- Fail
- N/A
-
Check integrity and report to the office if renewal is necessary. Picture of the fitting in question, its location height and load size are MANDATORY.
Signage
-
Check integrity of the signage and report to the office if renewal is necessary
- Pass
- Fail
- N/A
-
Check for failed or blackened tubes or lamps within the signage. Replace as necessary.
- Pass
- Fail
- N/A
-
Tube or lamp colour within the signage should conform with the original colour specification.
- Yes
- No
- N/A
-
Redundant tubes have been disposed of in a lamp coffin at the wholesalers and NOT returned to the yard, at the end of the working day.
- Yes
- No
- N/A
-
If the signage has Cold Cathode Tubes, check for faulty tubes of low brightness. Replace or re-process as necessary.
-
Disposal and/or re-processing of Cold Cathode Tubes (particularly mercury tubes) must be in accordance with statutory regulations.
-
Where replacement of a single tube reveals a loss of brightness in the remaining tubes, consideration must be given to block replacement or re-processing. Has this happened on any of the signs at this station and if so record the information below?
- Yes
- No
- N/A
-
Check the correct operation of the control gear for the signage. Is it working correctly?
- Pass
- Fail
- N/A
-
If parts are to be replaced this should be done on a like for like basis and the evidence recorded below.
- Yes
- No
- N/A
-
Check the security of the fittings. This includes gear trays and signage covers.
- Pass
- Fail
- N/A
-
Where corrosion has occurred picture evidence MUST be recorded along with measurements of the signage
-
Has the signage been left in a clean and tidy condition, finger print free and in full working order?
- Yes
- No
- N/A
