Title Page
-
Site conducted
-
Department
-
Station #
-
Unit #
-
Conducted on
-
Prepared by
-
Location
undefined
-
IF ITEM IS FAILED, TAKE A PHOTO AND PUT IN NOTES WHAT CAUSE FAILURE. IF FAIR, PUT NOTES
-
Apparatus Type:
- Pumper
- Tanker
- Service
- Rescue
- Brush
- Support
- Arial
-
Chassis Mfgr:
-
Yr. Mfgr:
-
VIN ID / Serial #
-
VIN TYPED
-
Engine Make/Model:
-
Engine Serial #
-
Mileage:
-
Miles Out Photo:
-
Hour Meter:
-
Pump Make/Model:
-
T-Case #
-
Pump Serial #
-
APPARATUS IMAGE
-
Check Engine Oil Level
-
Check Transmission Oil Level
-
Check Power Steering Fluid Level
-
Check Engine Coolant Level
-
Check Front Hub Oil
-
Check Rear End Oil Level
-
Check PTO and Gearbox Oil (Generator/Hydraulic Pump) IF APPLICABLE
-
Check Steering System (Pump, Hoses, Belts, ETC) IF LEAKING-FAIL
-
Visually Inspect and Operate Wiper Blades and Washers
-
Visually Inspect and Operate Windows & Mirrors
-
Visually Inspect Belts for Cracks & Wear
-
Visually Inspect Coolant Hoses & Lines for Cracks & Wears
-
Check for Leaks (Any Fluids)
-
Check Tires for Excessive Wear / Side Wall Damage / Cracks / Cuts
-
Check All Tire Tread Depth (6/32 Inches Recommend Replace)
-
Check Rim and Lug Nuts (All Lugs Must Be Torqued to 450-500 FT-LBS)
-
Check Park Brakes (If Vehicle Moves It Fails)(Must Have 120 PSI)
-
Check Brake Pads For Thickness (14/32 Recommend Replace)
-
Check Air Brake Parts (Drums, Slack Adjusters, Chambers, S-Cams)
-
Check Drive Line (Shafts, Hanger Bearing, U-Joints, and Straps)
-
Inspect Chassis Undercarriage Bolts (Loose, Missing, Broken)
-
Inspect Body Undercarriage for Broken Supports
-
Inspect Body Sub-Frame & Fasteners
APPARATUS BODY
-
Inspect & Lube Door Latches (IMAGE OF FAILED ITEMS)
-
Inspect & Lube Door Hinges or Tracks
-
Inspect Door Rubber Gaskets
-
Inspect Door Shocks (Measure Length for Replacement) (ADD IMAGE)
-
Check Cab Lift Cylinders (IF APPLICABLE)
-
Inspect Steps and Handrails
-
RECOMMENDATIONS (ADD IN NOTES) *ANYTHING THAT NEEDS ATTENTION BUT NOT CALLED OUT ABOVE*
ELECTRICAL
-
Check Master Battery Switch
-
Check Alternator Output (Add Photo)
-
Check Ignition Switch
-
Check Emergency Lights & Flashers
-
Check Gauges on Instrument Cluster (Speedometer, Tach, Fuel, Alt Output, etc)
-
Check Kussmaul (Charger, Auto Eject, Auto Pump) "IF AUTO EJECT FLAP IS BROKEN, MARK POOR AND TAKE PHOTO"
-
Check Headlights
-
Check Turn Signals
-
Check Brake Lights
-
Check Clearance Lights
-
Check Ground & Side Marker Lights
-
Check Step Lights
-
Check License Plate Light
-
Check Reverse Back Up Lights
-
Check Reverse Camera IF APPLICABLE
-
Check Pump Panel Lights
-
Check Pump Compartment Lights
-
Check Compartment Lights
-
Operate & Check Scene Lights/Spot Lights
-
Operate Generator (PTO, Portable, Hydraulic)
-
Operate & Check Light Tower
-
Clean Battery Terminals & Connections
-
Load Test Batteries
-
Batteries Pass or Fail
-
List CCA and CA
Final In-Service Inspection
-
Engine Oil Full
-
Transmission Fluid Full
-
Power Steering Fluid Full
-
Coolant Full
-
Fuel Level Good
-
Windshield Washer Fluid Full
-
Head Lights, Tail Lights, Clearance Lights and Signal Lights Working Properly
-
Brakes are operable
-
Tires are operable
-
Pump is operable
-
Transfer Case Full and Operable
-
Apparatus Starts
-
Apparatus Power Off and Plugged In
-
All used and unused supplies picked up and cleaned.
-
Notify Department Person In Charge and Delta Service Manager of any out of service issues and/or questionable items *BEFORE LEAVING TRUCK*
Filter Numbers
-
Oil Filter #
-
Fuel Filter #
-
Air Filter #
-
Coolant Filter #
-
Hydraulic Filter #