Information
-
Prepared by
-
Conducted on
-
Location
-
MFC Tool Size
-
MFC Tool Serial Number
What else was received with the MFC tool?
-
Calibration Ring?
-
Tool Wrenches?
-
Do wrenches fit tool slots properly? (If not, please provide image of wrench placed on tool slots)
-
Add media
-
Spare fingers included in MFC Kit?
-
Thumb Drive provided with calibration files for MFC Tool?
Tool Condition at time it was received?
-
Tool exterior clean
-
Add media
-
Tool Free of pipe wrench marks/scoring? (Throughout whole tool body)
-
Add media
-
Bull nose included with tool?
-
Clam shells removed from tool and springs inspected for visible damage?
-
Tool opened and closed to ensure functionality?
-
Tool met proper power requirements on initial communication (between surface system and tool), opening, and closing?
-
All fingers inspected for visible damage/wear? (Check finger functionality and ensure carbide tips are intact)
-
Add media
-
Pre-calibration performed on tool with accurate results?
Tool Condition at time it was returned?
-
Tool exterior clean
-
Add media
-
Tool Free of pipe wrench marks/scoring? (Throughout whole tool body)
-
Add media
-
Bull nose placed back on tool?
-
Clam shells removed from tool and springs inspected for visible damage?
-
Tool opened and closed to ensure functionality?
-
Tool met proper power requirements on initial communication (between surface system and tool), opening, and closing?
-
All fingers inspected for visible damage/wear? (Check finger functionality and ensure carbide tips are intact)
-
Add media
-
Tool cleaned with clam shells removed and while tool is in the open state?
-
Has the MFC run sheet been completed?