Title Page
-
Document No.
ON SITE INSPECTION & REPORT FOR SCHENCK VIBRATING SCREENS
Equipment Model No.
-
Equipment Model No.
Equipment Serial No.
-
Equipment Serial No.
Equipment No.
-
Equipment No.
Equipment Description
-
Equipment Description
-
Conducted on
-
Prepared by
-
Location
-
Personnel
ON-LINE INSPECTION CHECK LIST Visual inspection only
Exciter Gearbox
-
Visual inspection of exciters while running for any indication of oil leakage<br>NB: Labyrinths will shed grease when exciter is new. DO NOT re-grease Labyrinths. They are replenished by oil from the seals.
-
Check exciter while running for unusual noise.
-
Check and record exciter operating temperature.<br>(30oC above ambient is normal)
-
Ambient Temp………..…….°C
LH Temp……….….°C RH Temp………….°C -
Add Comments
Screen Drive and Drive Shafts
-
Check drive Motor Mountings for corrosion, looseness or excessive vibration.
-
Visually inspect Vibrator motor holding down bolts are all in position and secure.
-
Check Vibrator motors while running for unusual noise.<br>Check and record vibrator motor operating temperature.<br>(50oC above ambient is normal)
-
Ambient Temp……………….°C
Top LH ……………....°C RH………………°C -
Check Motor Bearings; listen for noise and record operating temperature.
-
Rear End………..………°C
Pulley End………………°C -
Check all Vee Belt Guards, Drive Shaft Guards, Intermediate Shaft Guards and Exciter Guards are in place and secure.
-
Check Lay Shaft Bearings for unusual noise.<br>Check and record Lay Shaft Bearing temperature.<br>(30oC above ambient is normal)
-
Ambient Temp………………………°C
Pulley end bearing………………….°C
Coupling end bearing……….………°C -
Drive Belts listen for possible breakage or loss of tension.
-
Add Comments
Isolation Frame
-
Check dampers temp<br>(replace any that are extremely low in temperature or high compared to the rest)
-
RHF-______°C, LHF-______°C
RHD-______°C, LHD-______°C
Screen Body
-
With screen running, check pattern of material flow. Bed must be evenly distributed over full width of deck.
-
With screen running, listen for possible loose bolts or unusual noise.
-
Check for unusual motion of screen while operating.
-
Check for material leakage over the side and back of the screen.<br>Check curtains.<br>Check Feed and Discharge chutes for spillage or corrosion.
-
Check for material leakage inside cross beams if applicable, indicates possible loose cleat or cracked cross beam.
-
Check for possible interference between screen body and stationary hoppers, chutes, material build-up and building beams.
-
Check for missing spray bars, leaks and blockages.<br>Check screen deck and side-clamp bars are in position.
Supports
-
Check condition of springs, material build-up around spring, broken springs, rubber grommets.
-
Check spring hangers and bases for corrosion and any visible wear.
-
Check Dust/Splash Curtains
Work Order / Task Priority Evaluation
Add Comments and supporting information here
-
Add Comments
-
Add drawing
-
Add media
-
Add signature
-
Select date
