FWT1 Panel Inspection 澳洲FWT1单元板块成品验收记录

1.Is the unit panel assembled? If so, two photos must be taken for this item (label photo + overall unit panel photo 单元板块是否完成组装？如果完成，此项需拍2张照片（标签照片+单元板块整体照片）

2.Are the partition dimensions of the unit board correct? 单元板的分格尺寸是否正确？

3.Is the direction of the hanging code on the unit board correct, and is the type correct ？单元板的挂码方向是否正确，类型是否正确？

4.s the gasket around the perimeter of the unit board complete, properly notched as required, and secure? 单元板的外围四周的胶条是否完整、按要求开缺、牢固？

5.Are there any obvious scratches on the glass, oxidation on the film surface, or dirt on the backboard?<br>玻璃有无明显划伤、膜面氧化、背板内脏等缺陷？

6.Is the surface adhesive smooth, straight, aesthetically pleasing, with even width, and no residual glue on the panel?<br><br>面胶是否顺滑平直美观、胶宽均匀、面板无残胶？

7.Is the drainage hole clear and unobstructed? 排水孔是否通畅？

8.Are the reinforcing pads and transition pieces for the horizontal and vertical fins, as well as other accessories, all securely installed?横竖飞翼的加强垫块及转接件等附件是否都安装牢固？

9.Does the glass transparency joint meet the ITP requirements? 玻璃透光缝是否符合ITP要求

10.Is the quality of the suspended window inspection qualified? What about the opening force? Is the sealing of the rubber strip adequate?悬窗检查相关质量是否合格？开启力度？胶条密封等？

11.Is the adhesion of the finished protection corrugated board firm and correctly positioned?<br><br>成品保护瓦楞板粘贴是否牢固、位置正确？

12.Have the residual adhesive from the seams at the four corners of the room been thoroughly cleaned? Is the overall cleaning adequate? Photos of each corner need to be taken.室内四个角拼缝残胶是否清理干净？整体清洁是否到位？需拍每个角的照片

13.Is the adhesion of the static film complete and even? 静电膜粘贴是否完整、平整？

Is the final acceptance qualified? 最终验收是否合格？