Information
-
Audit Title
-
Document No.
-
Client / Site
-
Conducted on
-
Prepared by
-
Location
-
Personnel
HARNESS IDENTIFICATION
-
Harness Manufacture
-
Model number
-
Harness Lot Number
-
Harness Serial number
-
Date of Manufacture
-
Date of First In Service
-
Harness EN 361 1 point rear dorsel.
-
Harness EN 361 2 point
-
Rescue harness EN 361 full body
-
Gender
-
Is the harness marked with the European "CE" mark?
LANYARD
-
Is the Lanyard to EN 354 and marked with the European "CE" mark?
-
Lanyard Serial number
-
Lanyard Manufacture
-
Lanyard Lot Number
-
Lanyard Model number
-
Lanyard length
- 1.0m
- 1.20m
- 1.30m
- 1.50m
- 1.75m
- 2.0m
-
Lanyard Type
-
Date of Manufacture
-
Date of First In Service
HARDWARE
-
D-rings<br>Check D-rings for rust or corrosion, distortion, cracks, breaks, and rough or sharp edges. D-rings should pivot freely.
-
Buckles<br>note any unusual wear, damage or distortion. On tongue type check that the roller and tongue move freely and that the tongue overlaps the fame. On quick release types check for broken plastic and that they will not release when one release is opened.
-
Karabiner<br>Check Karabiner for rust or corrosion, distortion, cracks, breaks, and rough or sharp edges. Karabiners should pivot freely. Note any unusual wear, damage or distortion. On tongue karabiners check that the roller and tongue move freely and that the tongue overlaps the buckle frame.Check the outer and center bars on friction and mating buckles for distortion. On quick release types check for broken plastic and that they will not release when one release is opened. Mating buckles should nest together.
WEBBING
-
Webbing<br>Inspect the entire length of all the webbing looking for frayed edges, broken fibers, pulled stitches, cuts, burns and chemical damage. Also look for mildew, discoloration, hard shiny spots, any webbing that has been marked with a felt pen, excessive hardness or brittleness or the Harness Fall Indicator deployment.
-
Stitching <br>Check all stitching for ripped or pulled stitches and to make sure the webbing joints are not loose. Also look for missing stitching, hard or shiny spots, or discoloration of stitching.
LABELS
-
Inspect to be certain that all harnesses and lanyard have a label that is legible and securely held in place.
OVERALL DISPOSITION
-
Harness is approved for use at time of inspection. (If NO, harness must be removed from service)
-
Lanyard is approved for use at time of inspection. (If NO, lanyard must be removed from service)
-
Name of the person Making this inspection
-
Date of inspection.
-
Date next inspection due.
