Nautical Roofing SAFETY MESH HANDOVER and ROOF ACCESS CERTIFICATE

• Project Name and/or NR Job Number

• Site Address

• Conducted on

  Date

• Roof Section/s

• Safety Mesh Installer

• Person Inspecting Mesh/Rail

• Document No.

To be completed by the site supervisor (Diagrams for installation available on MSDS in safety folder)

• MESH CRITERIA - Does the safety mesh materials comply with the performance requirements of AS/NZS 4389:1996?

  Yes

  No

  N/A

• PLACEMENT OF MESH - Has the safety mesh been installed in accordance with AS/NZS 4389:1996? If not, has the safety mesh been placed in accordance with manufacture's recommendations?

  Yes

  No

  N/A

• DO THE SIDE LAPS COMPLY WITH THE FOLLOWING REQUIREMENTS? The run of mesh should be side lapped by at least 150mm and if purlin spacing is greater than 1700mm, the overlap is tied between purlins.

  Yes

  No

  N/A

• DO THE END JOINS COMPLY WITH THE FOLLOWING REQUIREMENTS? Pass all longitudinal wires around, or through anchor points (wrapped around steel or wood purlins - passed through holes drilled in purlins - passed through 40mm long by 3.15mm staples) and tie each wire 4 times around the same wire OR if joining two pieces of wire as per the MSDS and manufacturer's specifications?

  Yes

  No

  N/A

• ROOF GUARD RAIL INSTALLED?

  Yes

  No

  N/A

• IF USING GUARD RAIL SYSTEM, IS IT APPROPRIATE FOR THE TYPE OF ROOF?

  Yes

  No

  N/A

• ROOF ACCESS GATE/S INSTALLED?

  Yes

  No

  N/A

• The information above has been received and sighted and as such access is granted to the following section/s of roof: (use grid lines or attach a marked up plan below):

• Attach marked up plans to show approved areas

  Media

• Add signature

  Sign

• Position

  Site Supervisor

  Safety Advisor