Service Lift Test Sheet

• Job Name & Address

• Conducted on

  Date

• Job Number

• Prepared by

• Deltron Lifts
  Elevator House
  Britannia Street
  Tividale
  Birmingham
  B69 2PG
  
  Telephone: 0330 124 2169
  Email: info@deltronlifts.co.uk

• Site Address
  Address

• Installation Contract Number

• Lift Number

• Contract Speed

• Power Supply

• Lift Model

• Number of Stops

• Motor RPM

• Contract Load

• Travel Distance

• Winding Unit

Electrical Safety Devices

• Pit Stop Switch

  Yes

  No

  N/A

• Overspeed Device

  Yes

  No

  N/A

• Overspeed Governor Rope

  Yes

  No

  N/A

• Safety Rope

  Yes

  No

  N/A

• Slack Rope/Chain Switch

  Yes

  No

  N/A

• Mains Isolator

  Yes

  No

  N/A

• Is Mains Isolate Fused

  Yes

  No

  N/A

• Is Mains Isolator Lockable

  Yes

  No

  N/A

• Is Journy Run Timer Fitted

  Yes

  No

  N/A

• Overload Set and Tested

  Yes

  No

  N/A

• Safety Circuit Fuse or Breaker

  Yes

  No

  N/A

• Stopping Device

  Yes

  No

  N/A

• Overtravel Limits

  Yes

  No

  N/A

Door Locking and Activating Ramps

• Mechanical Landing Door Lock Devices

  Yes

  No

  N/A

• Electrical Landing Door Lock Contacts

  Yes

  No

  N/A

• Pre Locks

  Yes

  No

  N/A

• Car Door Electrical Switches

  Yes

  No

  N/A

• Retiring Ramps

  Yes

  No

  N/A

• Fixed Ramps

  Yes

  No

  N/A

• Landing Door Emergency Release Mechanisms

  Yes

  No

  N/A

Suspension System

• Ropes Fitted Correctly & Equalised

  Yes

  No

  N/A

• Rope Terminations Checked

  Yes

  No

  N/A

• Chains Fitted Correctly

  Yes

  No

  N/A

• Chain Terminations Checked

  Yes

  No

  N/A

Brake System

• Brake Test Under Normal Load Conditions

  Yes

  No

  N/A

• Brake Test With 125% Of Rated Load

  Yes

  No

  N/A

Measurements of Current Or Power and Speed Of Lift

• Actual Power Supply - Voltage, Phases, Neutral and Hz

• Actual Motor Amps

• Earth Continuity

  Yes

  No

  N/A

• Does earthing the most remote landing lock cause the fuse to trip without delay ?

  Yes

  No

  N/A

• Does the Phase Failure operate

  Yes

  No

  N/A

• speed of car with half contract load in downward direction

  Yes

  No

  N/A

• In mid travel does the car exceed the rated speed by more than 10%

  Yes

  No

  N/A

• Check that the car Cannot be raised when the counterweight rests of the buffers

  Yes

  No

  N/A

• Top final limit distance

• Bottom final limit distance

Checking of Traction

• Car Stopped empty travel - Distance of travel in MM

• Car Stopped half contract load - Distance of travel in MM

• Car stopped 125% of rated load - Distance of travel in MM

Checking of Balance

• Load test Current

• Ok

  Yes

  No

  N/A

• Empty Car Up Current

• Ok

  Yes

  No

  N/A

• Empty Car Down Current

• Ok

  Yes

  No

  N/A

• Full Load Up Current

• Ok

  Yes

  No

  N/A

• Full load Down Current

• Ok

  Yes

  No

  N/A

Overspeed Governor

• Car Travelling in Down Direction

  Yes

  No

  N/A

• Counterweight Travelling in Down Direction

  Yes

  No

  N/A

• Note - The tripping of the Overspeed governor for the car should be 115% of the rated speed up to 0.63m/s
  
  The tripping speed of the speed of the Overspeed governor of the car should be 125% of the rated speed exceeding 0.63m/s
  
  The tripping speed of an Overspeed governor for a counterweight/balance weight safety gear shall not be higher than that of the car safety gear, not however exceeding it be more than 10%

Car/Counterweight or Balance weight Safety Gear

• Check the correct mounting, setting and soundness of the complete assembly

  Yes

  No

  N/A

• Car

  Yes

  No

  N/A

• Safety Gear Guide Rails

  Yes

  No

  N/A

• Counterweight ‘Balance Weight

  Yes

  No

  N/A

• Structure

  Yes

  No

  N/A

• Fixings and fixing to building

  Yes

  No

  N/A

• Car Safety Gear Test

  Yes

  No

  N/A

• Counterweight / Balance weight safety gear test

  Yes

  No

  N/A

• On completion of the above tests, check that no Deterioration has occurred that could adversely affect the normal use of the service lift.

  Yes

  No

  N/A

Final Limit Switches

• Final Limit Switches

  Yes

  No

  N/A

• Additional checks required

• With the car at the top floor measure the distance between the bottom of the counterweight and top of the buffer - distance in MM

• With the car at the bottom floor measure the distance between the bottom of the counterweight and top of the bottom of the steel work distance in MM

Other Checks

• Machine room 240vac Socket installed/connected

  Yes

  No

  N/A

• Car Sill Clearance

  Yes

  No

  N/A

• Labelling and signage

  Yes

  No

  N/A

• Electrical wiring diagrams left in machine room

  Yes

  No

  N/A

• Log card left in machine room

  Yes

  No

  N/A

• Emergency release key left in machine room

  Yes

  No

  N/A

Handover Checks

• All builders work items on GA drawings and builders notes complete

  Yes

  No

  N/A

• Are all installation items which the lift manufacturer is not responsible for in a state to allow the lift to be put into service

  Yes

  No

  N/A

• Lift demonstrated to customer including stopping at all floors

  Yes

  No

  N/A

• If the above two items are satisfactory does the lift comply with BS EN 81-3:2008

  Yes

  No

  N/A

Hand Winding Demonstration Given To:

• Names

• Lift Keys given to:

• Note: This is to certify that the above installation was completed and tested to BS EN 81-3:2008 ANNEX D in accordance with our contract

• Outstanding builders works

• Test engineers signature

  Sign

• Date of test

  Date

• Commissioning Engineer signature

  Sign

• Date of commisioning

  Date

• Customer Signature

  Sign

• Customers name

• Date

  Date