Site Safety Inspection

Weekly safety toolbox talk being performed by crew

Hazard communication Program including required SDS available?

First Aid Kit Available

Emergency Action Plan in place and reviewed with employees

Clear access to building site, work areas clean.

Slip/trip hazards removed

Adequate supply of portable water / including disposable drinking cups and waste container

Proper material storage

Are Fall Hazards Greater than 6 Feet Controlled?

Personal Fall Arrest System (harness/lanyard/anchors) installed, worn, and used properly?

Guardrail systems properly installed and maintained (39" above walking surface minimum with 200lbs force applied, proper strength with mid rail and toe board where necessary)

Holes 2" and greater in smallest dimension properly protected to prevent employee fall into or through as well as provide falling object protection. (Covers secured from accidental displacement and marked hole or cover)

Proper number of abc Fire extinguishers, charged, inspected visible (within 100 feet of each worker and 50 feet of any flammable liquids or hot works)

Proper fuel containers used

Hot works procedures adhered with? (Combustibles moved away from hot works or covered with fire blanket, all sparks controlled, fire watch procedures in place)

Compressed gas cylinders secured upright, and used properly

No smoking near flammables

Welding shields used to protect surrounding persons

Inspected for defects

Secured properly with two man procedure

Proper angle 4:1 pitch and 3 feet above landing

No carrying materials up ladder. Procedures in place (backpack, rope and tie off, mechanical equipment) to get material to roof safely.

Not using the top two steps of A frame ladder

Properly utilized in locked position

Used for its intended purpose and inspected for structural defects

GFCI tested and documented

Electrical systems have proper covers and no exposed wiring

Electrical cords in good condition

All ladders, scaffolding, and equipment kept a minimum of 10' from overhead power lines

Equipment properly locked out and de-energized

Tools and equipment inspected and in good condition?

Guards in place and properly used

Utility knives sharp and employees cutting away from the body

Powder tools used properly by trained employees

Proper clothing and work boots worn

Hard hats and safety glasses worn when required

Proper traffic vests worn when exposed to vehicular traffic

Gloves worn when required and necessary

Face shields worn when using abrasive wheel tools