Slag Plant - Deister Screen - PM1

Check oil level

Clean material from springs, snubber assemblies, feed box, drive components, etc.

Check for loose screen panels

Check v-belts for wear and tension

Check screen media support decks for wear

Check wear on screens and tension plates

Check oil level

Check feed box for wear and material build-up

Examine supporting coil springs, snubber coil springs and their retaining brackets / anchors for damage

Check discharge lip

Check motor base for debris that would prevent free movement

Check motor for evidence of excessive heat or damage

Clean caked on material from motor (for heat transfer)

Check wear on bucker bar wear strips

Check snubber assemblies, wear and adjustment

Check v-belts and sheaves (max 1" belt deflection at center)

Clean and replace any plugged or worn spray nozzles (if applicable)

Verify that there is > or = 2" of clearance between the screen body and any stationary object

Inspect the feed lip plates, feed lip wear liners and all side liners for wear and deterioration. Verify that they're securely held into place

Inspect screen support panels or brace panels and crown rubber for excessive wear, bent rails or cracked welds