BP Refrigeration PPM

Carry out a full thorough leak detection of shop floor cases, pipework(where accessible) and cold room evaporators

Carry out a vacuum clean of all island drain pump motors and associated pipework - test drain away & visually inspect condition of waste pipework

Check and refit any dropped or loose kick plates and panels

Visually inspect lighting and associated fittings and fixings for operation and damages

Visually inspect bumper rails and glass ends for damage

Check and test all night blinds are operational, including holding clips and magnetic curtain stop ends

Check and inspect risers are free from damage and tighten/replace fixings/screws

Visually inspect all base plates and shelving are secure and in good clean condition

Check RDM panel for any new or historical alarm issues

Check control temperature and operation are within desired temperature /adjust as necessary

Inspect component condition and operation are as desired

check and clean condenser

Check and clean condensate tray including drain outlet and runaway

visually inspect lighting and isolator switches are operational

Check door seals /gaskets are in good condition

Inspect door hinges and door heaters / transformers are operational

Check and test local isolation including plug supply and secondary isolator

Check lighting operational

Inspect Discharge condensate pipework condition (If poor order, replacement)

Check evaporators are clean and free from dust and dirt

Check coils are clean and probes are correctly positioned

Check door release is operational

Check seals and gaskets are in good condition

Check drains are clear

Check flooring is in good safe condition

Check lighting is operational

Check isolation is correct and adequately labelled

Check door seals for tears and damage. Order and replace and damaged seals

Check Doors retract automatically and tensioners are in good working order. Report any issues and order any required parts urgently

Check top and bottom hinge plates/pins for any signs of excessive wear. Report any issues and order parts required urgently. Isolate doors if necessary

Check all door handles are secure and in good working order. Report any damage and order required parts

Check all compressors are operational. Report any issues

Check all crankcase heaters are operational and connected

Carry out full leak test of all compressors, connections, shut off valves, condensers, pressure hoses etc. Repair and report any leaks found

Pressure Relief Valves- Check condition and and date of PRV

Check parameters and controls are adequately set

Check pipe clamps are of correct condition and no vibration is present

Check oil level/oil condition.

Check electrical components/contactors and overloads are in good operational condition. Tighten contacts and terminals. Replace and report any failed components

Clean components and internal housing

Check mains electrical isolation is functional and is good condition

Check and test condenser fan operation

Ensure LP/HP switches are set correctly and functional

Check all panels and doors are interlocked/re-fixed correctly

Remove any debris from vicinity and ensure area is left clean and tidy

Ensure site is clear of any refrigerant cylinders. Report and submit cylinder collection form for uplift