Charles Schwab Heating Water Boiler PFT

• Document No.

• Audit Title

• Client / Site

• Conducted on

  Date

• Prepared by

• Location
  Address

• Personnel

Mechanical Contractor

• Is piping installed and layout checked?

  Yes

  No

  N/A

• Are hangers/piping supports properly installed and spaced?

  Yes

  No

  N/A

• Are valves properly located and installed?

  Yes

  No

  N/A

• Is heating water piping completed and tested to all equipment?

  Yes

  No

  N/A

• Is the make up water piping system complete and operational?

  Yes

  No

  N/A

• Is pressure relief valve installed and piped to a safe location?

  Yes

  No

  N/A

• Has piping been completed, tested, and inspected by City/Owner?

  Yes

  No

  N/A

• Is vibration isolation installed installed on piping and equipment?

  Yes

  No

  N/A

• Are all temperature control wells and valves installed?

  Yes

  No

  N/A

• Has all equipment utilizing heating water been checked?

  Yes

  No

  N/A

• Sufficient load for Boilers as required for complete start-up?

• Are low point equipment drains installed?

  Yes

  No

  N/A

• Is chemical treatment installed and ready?

  Yes

  No

  N/A

• Is access for service provided?

  Yes

  No

  N/A

• Is unit installed per manufacturer instructions?

  Yes

  No

  N/A

• Is gas piping completed, tested, and inspected by city and owner?

  Yes

  No

  N/A

• Is gas pressure verified to be at listed inlet pressure on boiler?

  Yes

  No

  N/A

• Is gas pressure regulator vent piped to outside?

  Yes

  No

  N/A

• Has the manufacturer start up request sheet been completed?

  Yes

  No

  N/A

• Add signature

  Sign

Electrical Contractor

• Are power requirements for controls completed and turned on?

  Yes

  No

  N/A

• Is power available to disconnect/starter on boiler?

  Yes

  No

  N/A

• Is access to electrical clear and per NEC?

  Yes

  No

  N/A

• Is permanent lighting in place and powered on?

  Yes

  No

  N/A

• Add signature

  Sign

Control Contractor

• Is access to controls provided?

  Yes

  No

  N/A

• Has control contractor completed point to point check?

  Yes

  No

  N/A

• Are control panel terminations complete and is panel clean?

  Yes

  No

  N/A

• Add signature

  Sign

Insulation Contractor

• Is piping insulation complete per spec?

  Yes

  No

  N/A

• Add signature

  Sign

Chemical Treatment Contractor

• Are chemical feeder and glycol pump ready for use?

  Yes

  No

  N/A

• Are system chemicals onsite with MSDS sheets?

  Yes

  No

  N/A

• Add signature

  Sign

QMS

• Submitted Model #

• Submitted Voltage

• Has system check been completed?

  Yes

  No

  N/A

• Add signature

  Sign

Commissioning Authority

• Is system ready for start-up?

  Yes

  No

  N/A

• All must sign off before start-up.

• Add signature

  Sign

General Conditions, Photos and Misc Notes

• Add media

  Media