Title Page

  • Document No.

  • Audit Title

  • Client / Site

  • Conducted on

  • Prepared by

  • Location
  • Personnel

Dispensing and Use

  • Definitions Approved: approved or listed by a nationally recognized testing laboratory. Class I liquids: flammable liquids (see definition of flammable liquids). Class I liquids: flammable liquids having a flash point below 73å¼F and a boiling point below 100å¼F. Typical Class IA liquids include: acetaldehyde, ethyl ether, methyl ethyl ether, pentane, and petroleum ether. Class IB liquids: flammable liquids having a flash point below 73å¼F and having boiling points at or above 100å¼F. Typical Class IB liquids include: acetone, benzene, butyl acetate, denatured alcohol, ethyl alcohol, gasoline, gin (ethyl alcohol and water), heptane, hexane, isopropyl alcohol, methyl alcohol, methyl ethyl ketone, toluene, and jet fuels. Class IC liquids: flammable liquids having flash points at or above 73å¼F and below 100å¼F. Typical Class IC liquids include: banana oil (isoamyl acetate), butyl alcohol, propyl alcohol, styrene, turpentine, and xylene. Class II liquids: flammable liquids with flash points at or above 100å¼F and below 140å¼F. Typical Class II liquids include: diesel fuel, fuel oils, kerosene, Stoddard solvent, Anchor type car wash, and mineral spirits. Class III liquids: flammable liquids with flash points at or above 140å¼F. Class III liquids are subdivided into two subclasses: Class IIIA liquids include those with flashpoints at or above 140å¼F and below 200å¼F, except any mixture having components with flashpoints of 200å¼F, or higher, the total volume of which make up 99% of more of the total volume of the mixture. Class IIIB liquids include those with flashpoints at or above 200å¼F. This section does not cover Class IIIB liquids. Class IIIA liquids: flammable liquids with flash points at or above 140å¼F. Combustible liquid: any liquid having a flash point at or above 100å¼F. Combustible liquids are known as Class II and Class III liquids. Flammable liquid: any liquid having a flash point below 100å¼F, and have a vapor pressure not exceeding 40 psia (pounds per square inch absolute) at 100å¼F. Flammable liquids are known as Class I liquids and can be divided into Class IA, IB and IC. Flash point: the minimum temperature in degrees Fahrenheit at which a flammable liquid will give off sufficient vapors to form an ignitable mixture with air near the surface or in the container, but will not sustain combustion.

  • Are only approved pumps, drawing from the top of the storage containers, used to transfer flammable liquids?

  • Are only approved self-closing valves or faucets used in gravity transfer of flammable liquids from storage containers? [29 CFR 1910.106(e)(2)(iv)(d) and

  • Is air or gas pressure prohibited for transfer of flammable or combustible liquids unless the tank, drum or containers has been approved as a pressure vessel?

  • Are containers and portable tanks used for flammable liquids electrically bonded or grounded during transfers? [29 CFR 1926.152(e)(2) and 29 CFR1910.106(e)(3)(vi)]

  • Are leaks and spills of flammable or combustible liquids disposed of promptly and safely?

  • Are spills of flammable or combustible liquids cleaned up promptly?[29 CFR 1910.106(e)(9)(i)]

  • Is the use of flames or sources of ignition prohibited in areas where flammable vapors may be present? [NFPA 30]. Note: 29 CFR 1926.152(f)(3) requires a distance of at least 50 feet between any source of ignition and flammable liquids.

Storage and Use Quantities

  • Is storage of flammable and combustible liquids limited to that required for current activities and maintenance? [NFPA 30]

  • Outside of approved cabinets or storage rooms, are containers of Class I liquids limited to a capacity of one gallon, or two gallons, if safety cans are used? [NFPA 30: 4-5.5.2]

  • Are fewer than 10 gallons of Class I and Class II liquids stored outside of an approved storage cabinet or interior storage room (except in safety cans)? [NFPA 30 4-5.5.3]

  • Are fewer than 25 gallons of flammable liquids stored in safety cans outside of an approved storage cabinet or interior storage room?

  • Are fewer than 60 gallons of Class IIIA liquids stored outside of an approved storage cabinet or interior storage room? [NFPA 30 4-5.5.5]

Design and capacity of containers

  • Are only approved containers used for storing flammable or combustible liquids? [29 CFR 1910.106(d)(2)(i)] Note: All gasoline must be stored in approved containers.

  • Table 1

  • Are flammable and combustible liquid containers stored in accordance with the requirements of Table 1? [29 CFR 1910.106(d)(2)(iii)]

The templates available in our Public Library have been created by our customers and employees to help get you started using SafetyCulture's solutions. The templates are intended to be used as hypothetical examples only and should not be used as a substitute for professional advice. You should seek your own professional advice to determine if the use of a template is permissible in your workplace or jurisdiction. You should independently determine whether the template is suitable for your circumstances.