Title Page
-
Inspection document #
-
Site conducted
-
Conducted on
-
Prepared by (Name and position):
-
Location:
-
Forklift:
- Enforcer Fork Lift 15232
- NISSAN YG1F2A3OU FORKLIFT 3T
- FORKFORCE ALL TERRAIN FORKLIFT SER: 1703504899
- TOYOTA 7FGCU25 2.5T FORKLIFT SER: 1648
-
Machine last serviced date and hours:
-
Machine current hours:
-
Machine next service (due) date and hours:
-
Is the machine overdue for a service?
-
Plant pre-start may continue to be completed, but DO NOT USE THE MACHINE
PRE OPERATIONAL FORKLIFT INSPECTION
-
NOTE:
The accelerator, brakes, steering operation, drive control, tilt control, hoist and lowering control should always be operating smoothly. Once the machine is in operation and if a malfunction is identified, report immediately to your supervisor.
In the event of a fault being revealed at any time or if the forklift truck becomes unsafe in any way:
1. Report the matter immediately to your supervisor; and
2. If the fault or condition is immediately dangerous, isolate and tag out and do not use the forklift truck until it is rectified.
DO NOT TRY TO REPAIR THE FORKLIFT TRUCK YOURSELF
PRE OPERATIONAL CHECK
-
The lifting capacity is stated on the load data plate
- Yes
- No
- N/A
- I reported this issue in a previous inspection
-
The forklift is free from major physical damage (make note of dents, scratches and minor damage not noted on the previous inspection)
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The machine is free of fluid leaks (check for patches of fluid under the machine where it has been parked)
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
Overhead guard, load backrest extension, seat belt and other safety devices are attached properly?
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The tyres have the correct inflation and are free from damage
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The lift and tilt systems including pins, chains and anchor points are free from damage
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The heels of the forks free of cracks?
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The forks are properly attached and the locking clips are in the proper position
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
The fluid levels for the brakes, cooking water, engine oil, transmission oil and hydraulic system are sufficient
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
All inspected hoses are undamaged and in good condition
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
Machine is fuelled/charged and ready to operate
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
Ensure the machine is aequately fuelled prior to use
-
The horn is operating
- Yes
- Part
- No
- I reported this issue in a previous inspection
-
Are there any other issues worth noting
-
Issue details:
-
Has your inspection identified a risk that must be addressed before the machine can be used.
-
Provide a detailed justification for proceeding with using the machine below and contact management immediately to have the issue rectified.
-
Signature: