FRP Panels - duplicate - SafetyCulture

Title Page

Job Name
Job Number
Client / Site
Conducted on
Prepared by
Location
Foreman

1. Substrate to be free of debris.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
2. Staple end cap and division bar 16 inches on center.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
3. Panels to be cut with sheers.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
4. Apply adhesive with ¼ inch notched trowel.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
5. Apply adhesive over entire sheet. Apply within 1 inch of edge of panel.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
6. After sliding FRP sheet flush with division bar, back sheet out 1/8 inch to allow for expansion. Verify caulking of joints is not required.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
7. Outside corners: Use blue tape or cardboard to protect from damage.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
8. Clean excess glue off of panels as you go with Goof Off or similar product.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
9. Miter FRP trims cleanly.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
10. If installing FRP panels before quarry tile or base, use piece of tile base as a template to follow. If physical template is not available, GC must sign off on elevation. This ensures base and division bar meet cleanly.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
11. Cut holes with holesaw, caulk if necessary.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?
12. Read installation instructions. Check to see if “Rolling” is required.
Responsible Party
PCI Personnel Responsible For Correction?
Date Corrected?