Induction RPAS - Matrice 300RTK V1.1

• Site conducted

  Select

• Name of RPA Pilot being inducted

• Conducted on

  Date

• Matrice 300 - Specs
  Weight 6.3kg with two TB60 batteries. 7.1kg with H20T
  Maximum takeoff weight 9kg
  Maximum Payload 2.7kg
  H20T weight 828g
  IP45 when setup for flight - (see table below for more information)
  Speed - 60kmh - Sport - 82kmh
  Maximum wind speed - 54kmh
  
  Demo -
  Attach camera while RPA still in case
  Attach landing legs while still in case
  Remove RPA and unfold the Frame Arms
  Insert two TB60 batteries - show battery lock
  
  Identify -
  Antennas
  D-RTK Antennas
  Infrared and Vision sensors all sides
  ESC LED's
  Aircraft Status Indicators
  FPV camera
  Upward and downward beacons
  Auxiliary lights - top and bottom
  Power button
  Ports
  
  DJI AirSence - ADS-B transceiver
  
  Three propellor emergency landing.
  Right stick, north, south, east west. CSC to stop motors close to the ground.

  

• Aircraft Status Indicator Status

  

• IP45 Protection Rating

  

• Matrice 300

• Remote Control - Enterprise Smart Controller
  Two controllers - Advanced Dual Operator Mode
  Can switch full flight control and camera control between them, both directly connect to RPA
  Inbuilt battery as well as hot-swappable WB37
  Battery life -
  Built-in Approx 2.5 hours. Charge approx 2+ hours
  WB37 Approx 2 hours. Charge approx 70 minutes
  
  Identify -
  Touch screen
  Antennas
  Spare sticks
  Attach WB37
  Power button
  Back button - press or hold for Functions
  RTH
  Flight pause button
  Flight mode switch
  Status LED and Battery Level LED's
  5D button
  Confirm button
  Charging port
  Handle
  
  Lanyard hooks
  HDMI Port
  Micro SD card slot
  USB-A port
  Record button
  Focus / Shutter button
  C1 & C2 - also hold for Screen capture and record
  Gimbal control dials

  

• Smart Controller

• Intelligent Flight Battery - TB60
  Batteries always operate in the same pairs
  Each battery is a LiPo 12S, has a capacity of 5935 mAh, a voltage of 52.8V, and energy rating of 274Wh.
  Weight -1.35kg each
  Smart charge/ discharge functionality
  Water-resistant
  Do not drop the battery
  Battery level check
  IP45 when installed.
  
  Batteries can be swapped out without turning the RPA off. Remove one battery replace, wait 3 seconds and then replace the second battery.
  
  Manually heat batteries - hold the switch for 5 seconds. Hold for 5 seconds to turn off or automatically turns off after 30 minutes.
  Automatic heating occurs when the Matrice is turned on when the batteries are below 16 degrees.
  
  Both batteries are turned on at the same time by the power switch on the Matrice
  Removal and connection to Matrice.
  Don't charge straight after flight when hot
  Be careful to keep the power connector clean from dirt and fluff
  
  The ideal battery charging temperature is between 15°C and 40°C
  Ideally, the battery should be used in temperatures ranging from -20° C to 50° C
  Discharge in GO Pilot app set to start after 5 days (resets countdown whenever battery level button is pressed)
  Discharging automatically stops at around 60% and takes approximately 6 days When a battery has started to discourage it should not be flown until charged.
  The batteries should be stored between 40-60%
  Approximately 55 minutes of flight time without a payload

  

• Battery Level Indicators

  

• WB37 Battery
  Capacity of 4820 mAh, a voltage of 7.6V
  Do not drop the battery
  Battery level check
  Removal and connection to Smart controller
  Does not have a discharge feature - not necessary for battery type
  Takes about 70 minutes to charge from flat in the BS60.

  

• Batteries

• BS60 Battery Station
  Charges only 1 pair TB60's at a time - but charges 2 batteries with the most amount of remaining battery power first, NOT necessarily in pairs.
  About 60 minutes to fully charge the TB60 battery, and 30 minutes to charge from 20% to 90% battery level
  When the temperature of the battery is too low, it will warm up automatically before charging
  Charges 1 WB37 battery at a time - most amount of remaining battery power first. Takes 70 minutes.

  

• Status LED Indicator Descriptions

  

• BS60 Battery Station

• H20T Camera and Gimbal
  Weight 830 g
  3-axis
  ZOOM lens - 20M - 20x optical and 200x digital
  Video MP4 - resolution - 3840×2160@30fps (4KP30), 1920×1080@30fps (1080P30)
  Image JPEG - resolution 5184×3888
  
  WIDE lens - 12M
  Video MP4 - resolution 1920×1080@30fps (1080P30)
  Image JPEG - resolution 4056×3040
  
  Thermal lens
  Video Mp4 - 640x512 @ 30Hz (640P30)
  Image R-JPEG - resolution 640x512
  
  Laser Rangefinder
  Range - 3-1200 meters
  Micro SD card in the camera - all video and images are recorded to the one card and can be done at the same time - Current View, Wide Photo, Zoom Photo and Infrared Photo
  Tilts -120 degrees to +30 degrees
  Pans 320 degrees independent of Matrice
  
  Connect to Matrice. Red dots are locked.
  Note release lock on Matrice when removing the camera.

  

• Camera and Gimbal

• MicroSD Card Holders
  READY holder means cards are available for use
  USED holder means cards have images yet to be transferred for records
  HEADQUARTERS holder is for transferring cards to and from the flight area a HQ / ICC if needed
  Also contains microSD to SD card adaptor
  Be careful, only apply light pressure on tab when removing cards

  

• MicroSD Cards
  10 x 64GB U3 cards are provided in the Matrice kit

  

• Image handling

Practical on ground Demonstration

• Setup RPA and Controllers: Camera, landing gear, arms, batteries.

• Show Pilot app settings: HMS All menu items -

• Show Dual Controller features: Gimbal control Pilot Handoff - lock takeover Out of range - change to other controller

• H20T features: Move between IR - Wide - Zoom Set zoom level while in Wide view Double Tap Rangefinder

Practical Flight Demonstration

• Primary Flight Display: Speed Wheel - Horizonal speed - Wind speed and direction Navigation Display Obstacle Avoidance Display

• H20T Smart Track

• Comments:

• The current (as at this induction date) Matrice 300 manual is available at this link
  https://www.dji.com/au/downloads/products/matrice-300

• Induction conducted by

  Sign

• Do you have any suggestions to improve this template?

  Yes

  No

• Please add your comments on how to improve this Form.