LM90 / 110 monthly and weekly inspection

Is it the first of the month?

Is the fire extinguisher gauge in compliance?

Is the expiration date in compliance?

Is the pull tab up to compliance?

Is the fire extinguisher rust and damage free?

Is the monthly inspection tag punched for the appropriate date?

Are first aid kits complete and are the expiration dates compliant?

Are eye was kits sealed and in date?

Are spill kits complete, sealed and marked with todays date?

Do PPE boxes contain ear plugs, face shields, respirators, goggles, safety glasses, grout gloves, and work gloves?

Check hydraulic level

Check for hydraulic leaks. (use UV kit).

Remove exit water hose from heat exchanger and ensure there is no restriction of flow or oil in the water.

Check read outs on electrical compartment of power pack to ensure they seem to be functioning properly.

Check operation of PT selector. Every selection should change reading on operating pressure gauge.

Inspect all hydraulic hoses for damage or wear.

Inspect all guards, covers and latches. (wireline, bean pump, power pack, rig).

Clean rig with solvent sprayer.

Is charge pressure between 1 and 2 bar?

Is pilot pressure between 35 and 40 bar?

Are all gauges on control stand working?

Is wireline motor operating properly?

Is float valve working properly?

Is wireline worm drive undamaged and clean?

Is pawl tightened and working properly?

Are sprockets and chains in good working condition?

Are rollers free spinning and free of damage?

Drain and replace oil in crankcase on bean pump. fill to petcock valve (30w)

Check bean pump for oil leaks

Inspect crowns, balls and gaskets.

Inspect cylinders for leaks

Drain and replace head oil. Fill to sight glass when rig is flat

Check and clean chuck and foot clamp jaws.

Check and tighten all bolts. (footclamp, Carriage, wireline, bean pump, Head, etc.).

Adjust Wear Pads

Inspect Feed Frame for cracks or rust.

Inspect feed frame slides for excessive wear or damage.

Grease whole rig (ALL COMPONENTS) thoroughly

Dead head feed cylinder and inspect for leaks.

Inspect sheaves and ensure they roll freely and keeping wireline off of extension.

Inspect dip cylinder for leaks and easy moving pins.

Check all electrical cables for corrosion or damage.

Test laser guards, e-stops, and helper bypass.

change all hydraulic filters.

Is it Friday

Are Chuck jaws and foot clamp jaws in good order?

Grease rollers and sheaves.

Adjust wear pads

Tension, lube, and inspect chain and chain sheaves.

Check bean pump oil level.

Electric grease cables.

Check pop-off valve