Title Page

  • Customer Name:

  • Telephone Number:

  • Site Address:

  • Cylinder Make and Model:

  • Cylinder Serial Number:

  • Engineer Name:

  • Registered Operative ID Number

  • Company Name:

  • Company Address:

  • Service Date:

ALL SYSTEMS PRIMARY SETTINGS (indirect heating only)

  • Is the primary circuit a sealed or open-vented system?

  • What is the maximum primary flow temperature? (°C)

ALL SYSTEMS

  • What is the incoming static cold water pressure at the inlet to the system? (BAR)

  • Has a strainer been cleaned of installation debris (if fitted)?

  • Is the installation in a hard water area (above 200ppm)?

  • If yes, has a water scale reducer been fitted?

  • What is the hot water thermostat set temperature? (°C)

  • What is the maximum hot water flow rate at set thermostat temperature (measured at high flow outlet)? (L/min)

  • Time and temperature controls have been fitted in compliance with Part L of the Building Regulations?

  • Is the cylinder solar (or other renewable) compatible?

  • What is the hot water temperature at the nearest outlet? (°C)

  • All appropriate pipes have been insulated up to 1 metre or the point where they become concealed

  • Type of control system (if applicable) Y Plan?

UNVENTED SYSTEMS ONLY

  • Where is the pressure reducing valve situated (if fitted)?

  • What is the pressure reducing valve setting? (BAR)

  • Has a combined temperature and pressure relief valve and expansion valve been fitted and discharge tested?

  • The tundish and discharge pipework have been connected and terminated to Part G of the Building Regulations

  • Are all energy sources fitted with a cut out device?

  • Has the expansion vessel or internal air space been checked?

THERMAL STORES ONLY

  • What store temperature is achievable? (°C)

  • What is the maximum hot water temperature? (°C)

ALL INSTALLATIONS

  • The hot water system complies with the appropriate Building Regulations

  • The system has been installed and commissioned in accordance with the manufacturer’s instructions

  • The system controls have been demonstrated to and understood by the customer

  • The manufacturer’s literature, including Checklist and Service Record, has been explained and left with the customer

Signatures

  • Engineer Comments

  • Parts Used

  • Engineer Signature:

  • Customer Signature:

The templates available in our Public Library have been created by our customers and employees to help get you started using SafetyCulture's solutions. The templates are intended to be used as hypothetical examples only and should not be used as a substitute for professional advice. You should seek your own professional advice to determine if the use of a template is permissible in your workplace or jurisdiction. You should independently determine whether the template is suitable for your circumstances.