Title Page
-
Blow Mold General Floor Cleaning
-
Conducted on
-
Prepared by
-
Location
General Floor Cleaning and Mopping of Blow Mold Rooms
-
Dry sweep areas in blow mold around machines 1, 2 and 3
-
Dry sweep areas in blow mold around machines 4 and 5
-
Clean mop bucket and mop head (if used head) or (use new mop head) with hot water to remove oily residue from last use
-
Add clean hot water and Betco Ultra 2000 in a mix of 8 oz of Ultra 2000 to 1 gallon of hot water
-
Carefully move filled bucket to area you're going to mop and use attached mop wringer to get access water out of mop head
-
Mop the area using back and forth motion of the mop head to clean the floor
-
Make sure you mark the area with a Caution Cone or Caddy so that no one slips and falls while floor is still wet
-
Continue to mop between and around machines 1,2, and 3 first with the cleaning solution and rinse and wring out as often as you think is necessary
-
If water is dirty or oily please go to step 3 and repeat for machines 4 and 5 and Alpine floor
-
When all cleaning is complete, return the mop bucket and accessories to "Mops for Blow Mold" hanger location
-
Dump dirty water into trough drain and rinse it
-
Discard old mop head unless you think it's ok to use again (if it's black or gray throw it away into nearby trash)
-
Hang up mop handle and put bucket underneath the hanger location too
