Drill rig inspection

Whip checks and osha valves on air hoses

Engine oil hydraulic oil and engine coolant and Phill to proper level be sure all filter caps are on tight and in place

Engine drive belts adjust tension as required

All sliding, pivot and rotation points are properly greased

All worn, broken, missing or damaged parts are removed or repaired check frame welds for cracks contact Schnabel equipment immediately

Oil leaks. Report any engine oil loss immediately to Schnabel equipment

Engine does not have excessive oil gain and discoloration. report to Schnabel equipment immediately (engine and hydraulic)

Casing breaker is free of broken or loose jaws, teeth and hoses. Repair as needed

Rotary head slides, wipers and feed chain are free of excessive wear. Keep clean and replace as needed

Engine radiator and hydraulic oil cooler are free of blockages. Clean as needed

Machine is free of broken, loose or missing bolts. Replace as needed

All emergency stop controls are functioning properly. Do not operate equipment if not working properly. Contact Schnabel equiptment immediately

Engine air filter housing is free of damage or missing parts. Air intake hoses are free of damage and loose clamps. Tighten clamps and replace all damaged parts. Do not operate until repairs are made

Wiring is free of worn insulation or damaged wiring. Repair as needed

Engine and hydraulic oil temperature is functioning normally. Indicators may vary with machine. Report to Schnabel equipment any excessive heat indicated discontinue operating and repair

Casing breaker and front chain idler are clean and greased

Engine display monitor is functioning properly. Report to Schnabel equipment any fault codes

Engine is free of excessive engine exhaust smoke or loss of power. Report to Schnabel equipment any change

Hydraulic hammer and all fittings on hammer gearbox are greased every two hours of operation. Use Lubrplate 930AA only

Machine is free of grout and dirt buildup and away from breather and filler caps

Drain or winterize the gamma pump drilling cold weather. Flush with RV type anyfreeze. Check gamma pump oil fill as needed

When not in use turn ignition key off position. Remove ignition key, turn main power switch to off position. Lock all access panels and doors.

Operators manual

Fire extinguisher, full, proper placement

Tracks, condition, Drive lugs

Gauges\switches\hour meter

Winch line free of phrase and tangles