Steel Erection Quality Control Inspection

• Site conducted

  Select

• Conducted on

  Date

• Prepared by

• Location
  Address

Area that inspection was performed.

• undefined

Site Conditions / Weather

• Overall

  Good

  Fair

  Poor

  N/A

• Weather Conditions

  Clear

  Cloudy

  Rain/Snow

• Wind Speed

  Safe

  At Risk

  N/A

• Temperature

• Material storage / Laydown area

  Good

  Fair

  Poor

  N/A

• What is the reason for the Poor conditions?

Welding Rod Storage and Usage

• Was a new box of rods opened today?

  Yes

  No

  N/A

• Was rod oven operating at required minimum temperature?

  Yes

  No

  N/A

• What is the cause of rod oven not functioning properly?

• Supervisor work station

  Good

  Fair

  Poor

  N/A

Inspections Prior to Welding

• Welding procedure specification available?

  Yes

  No

  N/A

• Manufacturer certifications for welding consumables available?

  Yes

  No

  N/A

• Fit-up of groove welds

  Compliant

  Non-Compliant

  N/A

• Fit-up of fillet welds

  Compliant

  Non-Compliant

  N/A

• Check welding equipment

  Good

  Fair

  Poor

  N/A

Inspections During Welding

• Use of qualified welders

  Yes

  No

  N/A

• No welding over cracked tack welds

  Compliant

  Non-Compliant

  N/A

• Weld procedure followed?

  Yes

  No

  N/A

• Welding techniques

  Compliant

  Non-Compliant

  N/A

Inspections After Welding

• Welds cleaned?

  Yes

  No

  N/A

• Weld size, length, and locations.

• Welds meet visual acceptance criteria?

  Yes

  No

  N/A

• Arc Strikes

  Pass

  Fail

  N/A

• Backing removed and weld tabs removed if required?

  Yes

  No

  N/A

• Repair activites?

  Yes

  No

  N/A

• Welds are ready for third party inspections?

  Yes

  No

  N/A

Inspections Prior to Bolting

• Manufacture certifications available for fastener materials?

  Yes

  No

  N/A

• Fasteners marked in accordance with ASTM requirements?

  Yes

  No

  N/A

• Proper fasteners selected for for the joint detail? (Grade, type, bolt length)

  Yes

  No

  N/A

• Proper bolt procedure selected for the joint detail?

  Yes

  No

  N/A

• Connecting elements, including the appropriate faying surface condition and hole preparation, if specified, meet applicable requirements?

  Yes

  No

  N/A

• Pre-installation verification testing by installation personnel observed and documented for fastener assemblies and methods used?

  Yes

  No

  N/A

• Proper storage for bolts, nuts, washers, and other fasteners

  Yes

  No

  N/A

Inspections During Bolting

• Chapter N completed

  Yes

  No

  N/A

• Fastener assemblies, of suitable condition, placed in holes and washers (if required) are positioned as required?

  Yes

  No

  N/A

• Joints brought to the snug-tight condition prior to the pretensioning operation?

  Yes

  No

  N/A

• Fastener component not turned by the wrench prevented form rotating?

  Yes

  No

  N/A

• Fasteners are pretensioned in accordance with a method approved by the RCSC and progressing systematically from the most rigid point toward free edges?

  Yes

  No

  N/A

Inspection After Bolting

• Document acceptance or rejection of bolted connections?

  Yes

  No

  N/A