Information
-
Site Name
-
Site Address
-
Postcode
-
Engineer
-
Date of Survey/Sign-Off/Audit
-
Tesseract Number:
-
Survey Version No.
-
Date of Revision (where applicable)
-
Description of revision(s) where applicable
Building Information
-
Has consent been obtained for the installation?
-
Detail further information available in respect of planning or Landlords consent or action required
-
Is the building listed or in a conservation area?
-
Describe restrictions on installation due to listed building status or being in a conservation area
-
Note: It is the responsibility of the customer to obtain Landlord's permission for the dish(es)
-
Insert photographs of property in relation to surrounding area
-
Insert photograph of building elevation 1
-
Insert photograph of building elevation 2
-
Please use Dish Pointer to identify line of sight:
http://www.dishpointer.com/ -
Insert the Dish Pointer image (after entering the postcode and satellite) and highlight dish locations, existing dishes, size, service, direction of south, adjacent roads, cable routes and distance in metres:
Installation
Installation and Configuration
-
Describe dish location and access to location
-
Photograph of dish/dish location
-
State satellite dish size and configuration for the TRP service after any works completed
- TD78 Single
- TD78 Twin
- TD88 Single
- TD88 Twin
- SMC80 single
- SMC100 single
- 1.2 Single
- Zone 2
-
Was a new dish installed?
-
Was an existing dish removed and replaced?
-
Was a new Flexi-Block LNB holder (for a dual-feed dish) installed?
-
State type of LNB for TRP service
-
Was a new LNB Installed?
-
State type of satellite dish mount
-
Describe type of mount:
-
Was a new mount installed?
-
Satellite IF cable type
-
Satellite IF cable length (state length in meters)
-
Describe cable route and cable entry point
-
Photographs of cable route and cable entry point
-
Description of receiver location
-
Photograph of receiver/receiver location
-
Photograph of TRP service working on screen (unless connected to PC for distribution that others need to set up)
-
Receiver remote control on site and working?
-
Receiver asset number
-
Card serial number
-
Receiver Software Version (receiver to be updated on site to latest software version) - in Menu: Information
Record the following measurements at the receiver location
-
TRP Transmission parameters:
28.2° East - 11.426 MHz, H Pol, DVB-S, FEC 2/3, Symbol rate: 27.5 MS/s -
C/N (db)
-
MER (db)
-
Power (db)
Description of TV picture distribution
-
Method of TV picture distribution (RF, AV, HDMI or to PC, number of screens, receiver RF channel if distributed via RF (and must be below 60), Channel on TV etc)
General comments / Further actions required
-
Any additional comments
-
Any additional photos
Sign-Off
Client
-
I confirm the dish/receiver location(s), internal works, cable entry route(s) and point of entry are/were agreed
-
Client/Site Contact Name
-
Client/Site Contact Position
-
Client/Site Contact Signature
Engineer
-
Engineer Name
-
Engineer signature