Inspection

Are all supply registers mounted throughout home?

Are all return grilles mounted?

Do all returns have filters?

Are all thermostats mounted and wired up?

(If a zone system)Are all zone dampers wired to zone board?

Are all units sealed properly?

Are all refrigerant lines sweated in at attic?

Is all low voltage wiring tied in to furnaces/air handlers/zone boards?

Is a float switch installed in each pan?

Is flue pipe mounted/hung securely and has a clearance of 1"?

Are all condensation drains glued/supported properly throughout?

Is the gas gauge still holding 30psi?

Are all outdoor units set/sweated in?

Are all outdoor units level?

Are all outdoor units 3" above grade?

Are all outdoor units wire to disconnect?

Are all sidewall/soffit caps mounted and secured?

Is beauty ring installed on dante valve?(if applicaple)

Has a start up been completed?

Is house ready for start up? (Elaborate in notes if not ready)

Is house ready for final inspection?

Photos of Equipment

Indoor Furnace/s
Indoor Air Handler/s
Outdoor A/C condenser/s
Outdoor Heat Pump/s

Photos of Home

Front of home
Left side of home
Right side of home
Rear of home
Please note that this checklist is a hypothetical example and provides basic information only. It is not intended to take the place of, among other things, workplace, health and safety advice; medical advice, diagnosis, or treatment; or other applicable laws. You should also seek your own professional advice to determine if the use of such checklist is permissible in your workplace or jurisdiction.