Information
-
Select report Title
-
Project Name and/or NR Job Number
-
Site Address
-
Conducted on
-
Roof Section/s
-
Safety Mesh Installer
-
Person Inspecting Mesh/Rail
Form
SAFETY MESH (Diagrams for installation available on MSDS in safety folder)
-
MESH CRITERIA - Does the safety mesh materials comply with the performance requirements of AS/NZS 4389:2015 / HB39?
-
PLACEMENT OF MESH - Has the safety mesh been installed in accordance with AS/NZS 4389:2015 / HB39? If not, has the safety mesh been placed in accordance with manufacture's recommendations?
-
Is the mesh tied to the structure as per above with a minimum of 4 full turns
-
Select purlin spacing
-
Does the mesh have a side lap of a minimum 150mm
-
Does the mesh have a side lap of a minimum 150mm and fastened with 2mm ring fastener at 900mm centres between each purlin
-
Does the mesh have a side lap of a minimum of 300mm and fastened with 2mm ring fasteners at max 600mm centres between each purlin - both sides of the lap
-
Are there any joins in the mesh
-
Do the joins in the mesh match the above detail
EDGE PROTECTION
-
IF USING GUARD RAIL SYSTEM, IS IT APPROPRIATE FOR THE TYPE OF ROOF?
-
ROOF GUARD RAIL INSTALLED and HANDOVER CERTIFICATE RECEIVED?
-
ROOF ACCESS GATE/S INSTALLED?
-
The information above has been received and sighted and as such access is granted to the following section/s of roof: (use grid lines or attach a marked up plan below):
-
Attach marked up plans to show approved areas
-
Inspected by
-
Position