Information
-
ADCO Type of Inspection-Select the type based on the Title of the Inspection being conducted
-
Document No.
-
Client / Site
-
Conducted on
-
Contractor Being Inspected
-
Prepared by
-
Location
-
Personnel
-
An audit is a snapshot in time. Auditors will draw conclusions on the compliance status of the facility based on conditions observed and information provided by facility staff during the period of time the auditors are on site. Auditors are not responsible, nor can they be held accountable for activities, conditions, operations, actions or failure of actions by facility staff that may occur or not occur after the auditors leave the facility. Auditors shall not be held liable for any fines, penalties, or other sanctions that may be assessed against the audited facility by any state, county, city, or other local regulatory authority for any findings reported by the auditors in the audit report.
JOB INFORMATION
-
Job Safety Analysis Completed Daily?
-
Work areas properly signed and barricaded?
ELECTRICAL
-
Ground fault interrupters being used?
FALL PROTECTION
-
Are employee(s) using fall Protection?
-
Employees exposed to fall hazards tied off?
-
Employees below protected from falling objects?
FIRE PREVENTION
-
Adequate fire extinguishers, checked and accessible?
-
"No Smoking" posted and enforced near flammables?
FLOOR & WALL OPENINGS
-
All floor openings planked over or barricaded?
-
Perimeter protection in place?
-
Materials stored away from edge?
HAND and POWER TOOLS
-
Are Hand and Power Tools in use?
-
Guards in place on machines?
-
Correct tool being used for job at hand?
HOUSEKEEPING
-
Work areas neat?
-
Waste containers provided and used?
-
Are passageways and walkways clear of slip, trip, and fall hazards?
LADDERS
-
Are ladder(s) in use?
-
Ladders extended at least 36" above landing?
-
Ladders are secure to prevent slipping, sliding or falling?
-
Stepladders used in fully open position?
-
No step at top two rungs of stepladder?
MATERIAL HANDLING
-
Materials properly stored or stacked?
-
Employees using proper lifting techniques?
-
Proper number of workers for each operation?
PERSONAL PROTECTIVE EQUIPMENT
-
Hard hats being worn?
-
Safety glasses being worn?
-
Hearing protection being worn when required?
-
Traffic vests or high visibility clothing material being worn?
SCAFFOLDING
-
Is Scaffolding in use?
-
All scaffolding inspected daily?
WELDING AND BURNING
-
Is welding and burning occurring on the project?
-
Hot Work Permit Completed?
-
Fire Watch has been assigned? Shall be on site for a minimum of 30 minutes after completion. Confirm with client if additional time is required.
-
Fire extinguishers readily available?
-
Superintendent/Supervisor