Facility Standards Inspection

• Site conducted

  Select

• Conducted on

  Date

• Prepared by

• Location
  Address

Chassis & Floors

• Fee of Broken and/or cracked stringers

  Yes

  No

  N/A

• Adhesive used on center stringers

  Yes

  No

  N/A

• Decking is secured and seams sanded smooth

  Yes

  No

  N/A

• Sub-floor properly prepped and cleaned

  Yes

  No

  N/A

• Proper glue pattern with no glue on seams

  Yes

  No

  N/A

• Linoleum is stretched and secured properly

  Yes

  No

  N/A

Cabinet, Plumbing & appliance set

• Vinyl floor cut clear from the furnace footprint and foiled

  Yes

  No

  N/A

• No strained Pex fittings or kinked braided hoses

  Yes

  No

  N/A

Shelling

• Slide-out openings are correct width and square with bracing

  Yes

  No

  N/A

• Hurricane strapping is being installed properly

  Yes

  No

  N/A

• AC ducting is secured and in proper placement for registers

  Yes

  No

  N/A

Electrical

• 12v & 110v wires routed and secured 4"-12" from connection

  Yes

  No

  N/A

• Metal sleeves and or smash plates used where needed

  Yes

  No

  N/A

• Solar controllers are hooked up correctly & tested

  Yes

  No

  N/A

Metal / Fiberglass

• Are adhesives being applied in the correct areas

  Yes

  No

  N/A

• Insulation is filling all cavaties

  Yes

  No

  N/A

• Proper staple pattern being used on metal install

  Yes

  No

  N/A

• Staples in all low mesa's along front radius

  Yes

  No

  N/A

Decking

• Proper amount of adhesive used on rafters

  Yes

  No

  N/A

• Decking is tight and secure

  Yes

  No

  N/A

• Decking seams / ceiling panel seams are minimum 16" offset

  Yes

  No

  N/A

Rubber Roof

• Decking free from all debris and raised splinters

  Yes

  No

  N/A

• Proper amount of glue is being used and distributed evenly

  Yes

  No

  N/A

• Proper amount of membrane overhang at front

  Yes

  No

  N/A

• Gutter rail is straight and butt joints are tight / sealed

  Yes

  No

  N/A

• Self-leveling is neat and thorough with no excess

  Yes

  No

  N/A

• Is Dicor pump clean and functioning properly

  Select Yes No N/A

  • Yes
  • No
  • N/A

• Is air pressure set correctly

  Select Yes No N/A

  • Yes
  • No
  • N/A

Slide Outs

• Slide box is square

  Yes

  No

  N/A

• Slide box is insulated properly

  Yes

  No

  N/A

• Steel sleeves are being installed for 110v Romex through studs

  Yes

  No

  N/A

• Wiper seals are installed square, tight and sealed

  Yes

  No

  N/A

• Wiring proper length & secured and away from pinch points

  Yes

  No

  N/A

• Adjustment marks are properly in place

  Yes

  No

  N/A

• Slide room has proper seal compression Front / Rear, is centered in opening, & has been cycled

  Yes

  No

  N/A

Final

• All screws and debris off flooring and cabinets clean

  Yes

  No

  N/A

• Wall attachments and slides sealed completely & w/o excess

  Yes

  No

  N/A