Titan Fabrications - Trumpf Trumatic 500 Checklist

Hydraulics - Check oil level

Tool spray lubrication - Check oil level

Tool adapter - Clean

Chip exhaust: Chip flap - Clean

Stop pin - Clean

Pinion lubrication of the X and Y axes - Check oil level

Compressed-air filter with water separator - Drain Condensate

Check Chip exhaust: V-Ring on console

Clean support bar of tool magazine

Check dirt wipers of bearing blocks

Clean rack and guide rails

Clean table areas, small parts chute and rigid chutes

Check brushes around die adapter

Check vacuum of chip exhaust

Check oil level on X and Y axes gearboxes

Clean hydraulic oil cooler

Check grasping rings of clamp

Check if table needs adjusting

Compressed air filter with water separator - Check and clean sight glass as needed

Compressed air filter with water separator - Check and clean filter cartridge as needed

Check and clean mirrors as needed

Clean chip exhaust: screen and foam filter of side channel blower

Check pressure of hydraulic accumulator

Clean safety light barrier

Clean light barrier small parts chute (option)

Clean control cabinet fan

Anti-vibration installation - Check air pressure (option)

Check brushes on die adapter and change if needed

Tool spray lubrication - Check oil amount and adjust if needed

Pinion lubrication of X and Y-axes - Check and add oil if needed

Tool spray lubrication - Check and bleed if needed

Clean table support

Lubricate axial radial bearing of lower C-axis

Oil air filter/hydraulic system - Filter change

Lubricate bearing blocks (long)

Check hydraulic hoses

Check plug and terminal connections

X & Y axes gearboxes - Oil change

Hydraulics - Oil analysis

Hydraulic pump - Bleed after oil change

Chip exhaust: V ring of console - Check and exchange if defective

Dirt wipers of bearing blocks - Check and exchange if defective

Buffer battery CP/MEM 5/NT 1 - Change batteries

Needle bearing - Retractable clamps (option) - Check and lubricate

Inductive proximity Switch - Check when replacing