Title Page
-
Conducted on
-
Prepared by
-
Location
-
Are you signed in at the store?
-
Have you been inducted on where fire exits and assembly points are?
-
Check for correct operating temperature
-
Check for any repeating high temperature alarms multicast history and investigate as necessary
-
Check for correct probe readings
-
Check operation of evaporator fans
-
Replace as necessary
-
Yes replaced fan motor
-
No not required
-
Ensure fan mounting, fan blades and panels are secure
-
Clean air return grilles, Air supply honeycomb and all panels are correctly fitted
-
Leak test carried out
-
Evaporator coil
-
TEV connections
-
Service access points
-
Solenoid valve
-
Isolation valves
-
Interconnecting pipework
-
Flush and check condensate drain for leaks
-
Check defrost heaters
-
Check lighting operations and replace lamps and starters as necessary
-
Replace any damaged pipe insulation where necessary
-
Ensure services entries are sealed
-
Test operation of expansion valve
-
Check installation of phial position
-
Carry out manual forced defrost
-
Check that termination temperature is correct
-
Check operation of all controls
-
Carry out a visual check of drainage channels on all AHT auto defrost cabinets, should there be evidence of any damage to the drainage channel which exposes the heater wires, or if there is any evidence of scorching, the cabinet should be taken out of commission until rectified, and reported immediately to the regional director. Cabinets under warranty should be referred to AHT. Repairs to older units should be quoted to the appropriate region
-
Is cabinet under warranty
-
Yes
-
No
-
Quote required
-
Yes
-
No
-
Store: Signature agreeing the above requirements are completed
